T100 keypad - GSM-Forum

ceylon · 06-22-2004, 18:49

I recently broke the display of my T100, so I bought a new one second-hand from a friend. This phone worked fine at first, but some keys seem to get harder to press. Is it useful to replace the keypad?

I find it impossible to open up the phone; I can find two screws under the battery, but I can't figure out how to remove the top part.

Help is much appreciated!
Thanks a lot.

DeltaGSM · 06-22-2004, 18:59

there is 2 screw under top part, try little hard to open it.
clean board with thinner or alcohol 95%.

BR

ceylon · 06-22-2004, 19:06

I managed to open it by prying under the two clips, though I needed some assistance to break it open

. Many thanks!

06-22-2004, 18:49	#1 (permalink)
ceylon Junior Member Join Date: Jun 2004 Posts: 2 Member: 69845 Status: Offline Thanks Meter: 0	T100 keypad I recently broke the display of my T100, so I bought a new one second-hand from a friend. This phone worked fine at first, but some keys seem to get harder to press. Is it useful to replace the keypad? I find it impossible to open up the phone; I can find two screws under the battery, but I can't figure out how to remove the top part. Help is much appreciated! Thanks a lot.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sony Eric T100 keypads	Xanga	Sony Ericsson Hardware Repair	2	09-16-2006 02:26
samsung t100 keypad problem	gibso	VLSI, Conexant, Skyworks and Old Models	0	10-19-2004 12:40
samsung t100 keypad not working	gibso	VLSI, Conexant, Skyworks and Old Models	0	10-18-2004 13:03
T100 keypad hang	uwenk98	Sony Ericsson	6	12-12-2003 07:26
sonyericsson T100 keypad failure ..?	alf007	Sony Ericsson Hardware Repair	1	07-26-2003 08:50

06-22-2004, 18:59	#2 (permalink)
DeltaGSM No Life Poster Join Date: May 2004 Location: Bandung-Flasher.com Posts: 1,118 Member: 65947 Status: Offline Thanks Meter: 135	there is 2 screw under top part, try little hard to open it. clean board with thinner or alcohol 95%. BR

06-22-2004, 19:06	#3 (permalink)
ceylon Junior Member Join Date: Jun 2004 Posts: 2 Member: 69845 Status: Offline Thanks Meter: 0	I managed to open it by prying under the two clips, though I needed some assistance to break it open . Many thanks!