J120 after change IMEI powers off within 2 min

[JC_BY]

SmartMoto 3.11
S-Card: **Smart-Clip dongle, v 2.06, assigned Smart-Clip: **Europe, initializing... OK
Waiting for the phone to power on......OK
Sending boot...OK
Hardware IMEI: ***
Manufacturer: Intel, Model: 28F320W18T
Writing new IMEI ***...OK
Turning phone off

[Mr.Tinkertrain]

@ JC_BY,

IMEI section of SmartMoto service software was implemented by developer of this program for repair (original IMEI restore) purposes only!
For some models IMEI could be restored simply by connecting the handset to SmartMoto via Smart-Clip as for flashing.
Some models require to be flashed with “IMEI repair firmware patch”, only after that IMEI could be restored.
In some cases flash chip on phone’s PCB requires to be replaced, to allow user to restore IMEI.

However, every user that applies to this option must remember the original IMEI to be able to restore it. In any case if SmartMoto user, during phone repair process, applies IMEI that differs from the original IMEI, which was previously set with the phone, is doing that on his own responsibility.

Developer of SmartMoto software does not take any responsibility for any incorrect use of that program.




Best Regards
Smart-clip team
www.smart-clip.com
www.scoutdongle.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

[JC_BY]

Originally Posted by Mr.Tinkertrain

@ JC_BY,

IMEI section of SmartMoto service software was implemented by developer of this program for repair (original IMEI restore) purposes only!
For some models IMEI could be restored simply by connecting the handset to SmartMoto via Smart-Clip as for flashing.
Some models require to be flashed with “IMEI repair firmware patch”, only after that IMEI could be restored.
In some cases flash chip on phone’s PCB requires to be replaced, to allow user to restore IMEI.

However, every user that applies to this option must remember the original IMEI to be able to restore it. In any case if SmartMoto user, during phone repair process, applies IMEI that differs from the original IMEI, which was previously set with the phone, is doing that on his own responsibility.

Developer of SmartMoto software does not take any responsibility for any incorrect use of that program.

It seems that solution only for repair original IMEI
because with J110i I have same problem - it powers off within 2 min after change IMEI

SmartMoto 3.12
S-Card: *Smart-Clip dongle, v 2.07, assigned Smart-Clip: *Europe, initializing... OK
Waiting for the phone to power on......OK
Sending boot...OK
Hardware IMEI: 3583720******7
Manufacturer: ST, Model: M58WR032ET
Writing new IMEI 358372******6...OK
Turning phone off