PLEASE ADD VODAFONE-555 for unlock

[benny Haraba]

TRIED WITH FAIL HERE ARE LOGS:
CABLE TO USE LGW300
SmartMoto 4.29
S-Card: XXXXXXXXX Smart-Clip dongle, v 3.10, assigned Smart-Clip: XXXXXXXXX Europe, initializing... OK
Z3X BOX Serial Port (COM8), provider - FTDI, drv. ver. 2.4.16.0 from 2/17/2009
MCU: MT6235, HW rev. A.04, SW rev. A.01
Release the Power ON button
Sending boot...com error, 0x04
Preparing...Com error 0x03

[GSM_Support]

@ benny Haraba,

Sending boot...com error, 0x04
Preparing...Com error 0x03

This error usually shows that wrong drivers were installed.
Install drivers that are recommended by our team and try running unlock operation once again.
Issues you're dealing with will be solved.

Best Regards
GSMServer team

[benny Haraba]

Originally Posted by GSM_Support

@ benny Haraba,


This error usually shows that wrong drivers were installed.
Install drivers that are recommended by our team and try running unlock operation once again.
Issues you're dealing with will be solved.

Best Regards
GSMServer team

I did not use a USB cable, used cable for LGW300 then did not expect to have usb drivers conflict connected to com 8 as shown on the logs

[GSM_Support]

@ benny Haraba,

As shown on the logs wrong FTDI drivers are installed.
Issue you're dealing with can be resolved with the drivers update.

Best Regards
GSMServer team

[benny Haraba]

Originally Posted by GSM_Support

@ benny Haraba,


This error usually shows that wrong drivers were installed.
Install drivers that are recommended by our team and try running unlock operation once again.
Issues you're dealing with will be solved.

Best Regards
GSMServer team

Can you assist how to install these drives as it is not an exe not only that normally we use comport for other gadgets

[DrScorpio]

@ benny Haraba

Please connect your box to PC. Then open device manager and update driver.
1. Select Install from a list or specific location
2. Show path to folder were you did extract this driver
3. Complete installation of it and restart your PC.

[benny Haraba]

Originally Posted by DrScorpio

@ benny Haraba

Please connect your box to PC. Then open device manager and update driver.
1. Select Install from a list or specific location
2. Show path to folder were you did extract this driver
3. Complete installation of it and restart your PC.

Already installed I will try and post results thanks in advance

[balar]

Ok this method with pinout is not working
I use infinity box as interface and RJ45 Cable GM750 = LG GW300

Reading unlock code OK

USB Serial Port (COM18), provider - FTDI, drv. ver. 2.6.0.0 from 2009-10-22
MCU: MT6235, HW rev. A.04, SW rev. A.01
Release the Power ON button
Testing external RAM...64 Mb
Architecture: NAND, Manufacturer: Samsung, Chip model not detected [EC00A1-15]
Flash size - 128 Mb, Page size - 2048, Bad blocks - 2
Firmware size - 36 Mb, Filesystem size - 91.50 Mb
Firmware - V555X-2AVDIE1 75C XR75FH78 JRD35_09B_PCB01_GPRS_MT6235B_S01.MAUI_09B_W09_52_S P1_V12_F14
Hardware IMEI: 356694043932151
Calculating unlock codes...OK