Incorrect parameters were submitted - GSM-Forum

vijeeshkannur · 10-11-2009, 09:14

when i tried to flash E490 in nspro it shows "Incorrect parameters were submitted"

NADEEM GONDAL · 10-11-2009, 09:18

Set NSpro Port on com Port Lower Than COM20 then Try again.
If You are Using USB Flashing mode, Make Sure That The Port Emulated By The phone is on COM port Lower Than COM50

vijeeshkannur · 10-11-2009, 12:10

Set NsPro port on com port lower than COM20 and now working OK

thx NADEEM GONDAL and Elco

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
incorrect parameters were submited	unlocker_786	NSPRO	4	11-14-2008 12:50
incorrect parameters were submited	Mohsin-*	NSPRO	1	08-05-2008 14:12
Incorrect parameters were submitted	beniaminpl	NSPRO	2	03-26-2008 09:22
Incorrect Parameters were submitted when trying to flash E810.....	Burnt Cobba	NSPRO	4	10-01-2006 21:04
Problem to flash E720 and S410i incorrect parameters were submitted	gsmnice	NSPRO	4	07-04-2006 11:21

10-11-2009, 09:18	#2 (permalink)
NADEEM GONDAL No Life Poster Join Date: Aug 2007 Location: England Posts: 3,691 Member: 575900 Status: Offline Thanks Meter: 3,177	Set NSpro Port on com Port Lower Than COM20 then Try again. If You are Using USB Flashing mode, Make Sure That The Port Emulated By The phone is on COM port Lower Than COM50

10-11-2009, 12:10	#3 (permalink)
vijeeshkannur Freak Poster Join Date: Sep 2007 Location: KERALA,INDIA Age: 38 Posts: 297 Member: 597241 Status: Offline Sonork: 100.1575009 Thanks Meter: 85	Set NsPro port on com port lower than COM20 and now working OK thx NADEEM GONDAL and Elco