PBB S/// v2.0 - all new ARM phones flash/decustomization added
 

PBB S/// v2.0:

- added read all lock/unlock codes for new ARM based phones
- added MAIN flashing for new ARM based phones
- added FS (Files System) flashing for new ARM based phones
- added SFA (Signed File Archive) flashing for new ARM based phones
- added flash files fore new ARM phones in support area
- corrected some bugs in fast speed communication at 921kbps


Best regards,
Zulea

OMG Zulea is on he's mode :) i like this hehehe :D Way to gooo!!!!

@zulea,

Where is v2.0???only v1.2 in support page....

Now is there. Sorry, upload delays.
Also not all flash files is finished in upload, right now uploading more.

Best regards,
Zulea

i want to know if you people know the song of TINA TURNER- SIMPLY THE BEST and the movie THE ONE :D :D :D :D

10x zulea for this update

NIce, will do some testing later. Will v2.0 just ignore CID36 phones when connected ?
I have a strange request, can you make it possible to choose Com-ports higher than Com32 ? I have many virtual com-ports and only my T28 cable is in this range.

Regards

Insight

- On CID36 phones is reported "Unsupported CID" and software don't even finish connect procedure with phone. So, not any problem.
- In next version will update port list dinamic from registry, and only (and all) available ports on your system will be there for selection. Until new release, try change your virtual port number for DSS, USB->COM adapter or Fighter cable to a lower number than 32.

Best regards,
Zulea

we all love Romanian;first of all Zulea,then George Hagi,Mircea Lucescu,Gabriel Pancu,*******....:):)you are a good team man..thnx for the update..:):)
WBR;
maxijazz

Simply the best...

thanks


BR
Lampin

@Zulea

Have tried flashing my K700i, but get error and strange CID detection. It's CID29 and it detected OK when I added battry/channel menu using T28 cable.
The battery is fully charged, and I changed DSS25 port to Com32. PC was rebooted afterwards. Usually when I flash SFA packs I do I first flash MAIN file and then SFA. In v20 there is no possibility to flash MAIN and SFA in same job, as SFA goes grey when MAIN is selected. I also find it strange to flash SFA only without first flashing MAIN. Can it be the DSS driver that makes conflict, it's the "old" one from PBB area. I have some other FTDI devices, maybe they dont like eachother :-)
Maybe im just too used to other programs, but please help me with this one.

Regards

Insight

Is it possible to ad "settings remember future" ( Interface and COM Port ) ???

thanx for new version, PBB have great support.



regards
Sethxp.com

hw about z500a?


cn pbb se unlock this unit??????????

what about k300
 

@Zulea
what about K300 sopport. unlock possible by pbb v2?

nice update :)
we will test and tell you

Good job...keep it up...

Regards
Mackie