Need pinout for O3 818

[sagtel]

need pinout for O3 818 connector_2x6_mini
cpu type: ARM_MT6205-ENSL-AJ05C

[InfinitySupport]

Due to a lot of different models with the same name but absolutely different hardware,
bottom connectors and different pinouts we recommend you to include the next info:
1. detailed description of model
2. phone CPU chip name
3. phone PCB photo (Rx/Tx/Gnd test-points may exist on phone PCB)
4. attach phone photo
5. attach phone bottom connector photo
6. include information about Gnd and Charge pins on phone bottom connector

After you have this information prepared, check the next detailed description how to get pinout for your model:
use "Cable Selector": http://forum.gsmhosting.com/vbb/showthread.php?t=398297
if not helps, please read: C:\Program Files\InfinityBox\pinout\ChineseMiracle\
if not helps, please read: http:///vbb/showpo...36&postcount=7
if not helps, please read: http:///vbb/showthread.php?t=433447

[Moderate]

Originally Posted by sagtel

need pinout for O3 818 connector_2x6_mini
cpu type: ARM_MT6205-ENSL-AJ05C

Hi brother i had the same Mobile but Different Name O3 V758.
Same hardware exact as yours and same connector same PCB.

here is the pinouts

GND --Anywhere on the PCB.
Rx --- 3
Tx --- 5

But one thing to notice is that i tried this at different speed but finally it worked at 115200.At higher speed it wasnt connecting at all.So make sure that use the aboe mentioned speed to work this pinouts.I am not sure it works for you cause it is china mobile but one thing is that same mobile and same hardware same Connector should work for you also.

Regards,
Moderate.

[sagtel]

thank you moderate
pinout tested ok workink 1000%