OT 380 cant detect - GSM-Forum

free1600 · 04-13-2011, 01:16

Hy,
need some help to detect alcatel ot 380.
I have 2.80V on 4 and 5 pinouts and GND is 6.
I tried with 4 Tx 5 Rx and 4 Rx and 5 Tx but no connection.
I have 2.80V on 2 pinout also and make combinations but no detection.

/1 2 3 4 5\
|6 7 8 9 10|

If somebody have the correct pinout please post it.

Thanks,
free1600

YellowBoss · 04-13-2011, 10:21

Hello,

I think that this phone pinout should be the same as Alcatel OT-701.
If it's impossible to connect phone via bottom connector, try to use test points under battery.

free1600 · 04-22-2011, 16:33

Thanks,
is what I've done finally...
And when measure voltage on 4 and 5 bottom pinouts will be same like on the test points (tx rx)(after the loader was send) There must be a trick to connect the phone with the bottom pinouts because they are not active to send the loader...

04-13-2011, 01:16	#1 (permalink)
free1600 No Life Poster Join Date: Mar 2007 Location: /Fr/Ch\Ro\ Age: 39 Posts: 1,334 Member: 467911 Status: Offline Thanks Meter: 351	OT 380 cant detect Hy, need some help to detect alcatel ot 380. I have 2.80V on 4 and 5 pinouts and GND is 6. I tried with 4 Tx 5 Rx and 4 Rx and 5 Tx but no connection. I have 2.80V on 2 pinout also and make combinations but no detection. /1 2 3 4 5\ \|6 7 8 9 10\| If somebody have the correct pinout please post it. Thanks, free1600

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Police Radar Detection	grape	Off Topic Zone	8	02-19-2004 14:36
cant read 3210 V06.00(atmel eeprom 24C128)from adr. 0200000-0400000	gaz	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	1	03-17-2001 15:07
I CANT GET DEJAN TO WORK!	dario	Nokia Hardware & Hardware Repair	1	01-27-2001 11:01
i cant unlock this ver!!!	Satanael	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	1	10-30-2000 22:22
cant unlock CSI eeprom	Stryker	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	9	08-20-2000 13:00

04-13-2011, 10:21	#2 (permalink)
YellowBoss Product Supporter Join Date: Jun 2009 Location: private Posts: 36,472 Member: 1043909 Status: Offline Thanks Meter: 60,926	Hello, I think that this phone pinout should be the same as Alcatel OT-701. If it's impossible to connect phone via bottom connector, try to use test points under battery.

04-22-2011, 16:33	#3 (permalink)
free1600 No Life Poster Join Date: Mar 2007 Location: /Fr/Ch\Ro\ Age: 39 Posts: 1,334 Member: 467911 Status: Offline Thanks Meter: 351	Thanks, is what I've done finally... And when measure voltage on 4 and 5 bottom pinouts will be same like on the test points (tx rx)(after the loader was send) There must be a trick to connect the phone with the bottom pinouts because they are not active to send the loader...