OT222 problem
 

How can i use flash file from support?
Phone flashed with 222X-2CALPL1-168_XO16AS01_JRD23_NEP_08A_PCB01_GSM_MT6223_S00.MA UI_08A_W08_36_SP1_V28_2010-01-20_En_Ru_Pl_De_Cz.B0M.bin
is semidead... blink only with logo...

Plz post detail you want this firmware or write this firmware phone will dameg
before any comment we need want you want

br-deepesh

I need polish language in such phones as alcatel. So i found file in support area and i wrote it into the phone. Now phone only blink with logo...

So conclusion is my question above...

Is that simple enough for you?

Friend!You've got to flashing with the same firmware that the phone had.
Regards
Haicha

can you tried to complete formate your set and if you have backup then write it your phone will back in normal

But i need Polish language in this phone ! MModule is not refined for MT6223.
Backups created during flash are useless too.
Language editor from sMobi is not good tool and not support it, and programmer is too lazy to research problem.

hello!

please open operation.log file and find first flashing log.
there you will see your phone's original software version.
I am sure it is different to one you used for flashing.
difference even in 1 digit can cause dead or rebooting phone

Did you read my posts from begin? I need Polish inside. Not any but Polish.

Rework that program, ( prepare it to read for editor saving sec zone ) make possibility to write SEC ZONE back to bring phone to life after use another flash file or edited via poor editor from sMobi.


btw: i have backup

hello!

I dont understand, can you at least write back your original backup?

Yes i can. But it's not my problem.
I need Polish language.
I need posibility to edit language in all alcatels builded on MTK.(lazy sMobi :( )
I need to write edited soft without problems with sec zone.
How can i use security backap created during flashing?