Please help me Infinity Team

[koala4791]

Dear Team.I bought infinity box 1 week ago .and i would like to do my first unlocking with the box.But iam confusing with the task.I found out the 2600c -2 rm 340 pinouts from the internet and i soldered my infinity box J-TAC cable on the pinouts of the phone.And started the Nokia dct4 +tool to press the connection button but nothing happening.My questions For infinity box supporter
1. My J-TAC cable has 5 outs brown [gnd],black [GND],yellow[vpp],red[rx],orange[tx], These are in good matched with color and function?
2.Am i using the right cable for this job?
If not what cable and tool and method should i use for this task?
3.Where is the other functions of the cable [vcc,bsi,btemp,mbus]?.
4.Sorry if i look like very beginer but this is my first unlocking


Identification: base
Dongle serial No (S/N):
Firmware version: 0116.02
Dongle status: activated
"UK edition" status: Off
Last launched application: 0015 v.0130
Active modules:
- 00: base
- 04: Pin-Finder Adapter
Support area:
- Username:
- Password:
Dongle parameters checksum: 61C838

[YellowBoss]

Hello,

Please, check this thread: http://forum.gsmhosting.com/vbb/f296...t-team-998163/
As I remember information about cables was posted there.

[koala4791]

Originally Posted by YellowBoss

Hello,

Please, check this thread: http://forum.gsmhosting.com/vbb/f296...t-team-998163/
As I remember information about cables was posted there.

Nice support thank you Yellow Boss