make j132 cable for setool

[haamidd]

here is the way for make this cable

needed tool : 1- 8 pin cable (jaf or uni) 2-usb port 3-setool and ufs

cut a cable such as jaf you see some wire you need 3 wire green red and orange and cut other ,such as below picture connect to usb but this picture is not correct you must make inversly connect green wire to number 5 and orange to number 3 and red wire to number 4. yes the cable is maked

for use this cable you must choose ufs interface on setool and conect this cabl to ufs box and signe mode in setting be active then keep 2 and 5 nember on phone conect cable and press power shortly

this is a log of identify with this way
Found 2 FTDI device(s).
UFS #74702 READY
SIGNED MODE (USING SERVER)
CFG:100000000000
PLEASE ATTACH TURNED OFF PHONE NOW
PRESS "POWER ON" BUTTON SHORTLY...
PROCEDURE WAS STOPPED BY USER
supported phone was not detected
Can't load ID loader !
Elapsed: 37 secs.
SIGNED MODE (USING SERVER)
CFG:100000000000
PLEASE ATTACH TURNED OFF PHONE NOW
PRESS "POWER ON" BUTTON SHORTLY...

EROM "R5A038" AID: 0001
SOFTWARE AID: 0001
SIMLOCK STATE: "NOT_TAMPERED"
LOADER AID: 0002
FLASH ID: "0020/88C0"
LOADER VERSION: "R3A011"

PHONE IMEI:357107028938***
MODEL (from GDFS): J132
FACTORY CXC: CXC1250616_R5A038
CURRENT CXC: 1211-2311_R1CA001
CURRENT CDA: 1213-3158_R8A
Elapsed: 21 secs

اموزش ساخت کابل j132 برای setool - انجمن متخصصین تلفن همراه

for picture go to above link


iran is the big country with big man`s