Need a picture for modify the Original SH888 cable

[Saint33754983]

Need a picture or schema for modify the Original SH888 cable to use it for flashing with cruiser.


must short 2 pins but dont know which pins

[Saint33754983]

For all who need to Flash old ericsson phones

use the original Com port cable that comes with the SH888 and short pins 7 and 12 on the phone connector.

(in other Forum stays connect pin 7 and pin 8)

than you can flash the old phones with cruiser.

I have repaired a tampered SH888 phone with this simple cable mod.


Here is a pinout page for it

http://pinouts.ru/CellularPhones-A-N...8_pinout.shtml


1 Audio Out
2 Audio In
3 Accessory Sense. GND to enable External Mic and Speaker (Analog)
4 Audio Signal GND
5 Portable handsfree In. Internal/external mic and ear (0=External - open=Internal)
6 Music Mute Out, High when phone is used.
7 In Flash Memory Voltage and Service Voltage,
In 0V=normal,+5V=test, +12V=test+flash Test. Switch phone off and provide +5V and switch back on. (set comms at 9600, n,8,1)
8 Logic Out, Status On. Sources over 100mA. +3.3V output
9 TX (Data Out) from Mobile Station.
Debug messages appear here at 112KBaud when in debug mode. TTL
10 Digital Ground and DC return
11 Rx (Data in) TTL
12 DC in for battery charging,
DC out for accessory power + external power supply 7.2Volt - 600mA