t10 power on problem - GSM-Forum

ron_baxter · 07-08-2001, 03:30

i can't get my t10 to power on after a flash basically the phone is connected but everything i use times out

volcan · 07-08-2001, 11:32

try to flash with Ne121, or datex

ronkor2000 · 07-12-2001, 22:32

What prog did you use to flash it?
If you use ATR, pin 5 and 6 have to be bridged, standard datacables don't have this. You can bridge it yourself with a piece of alufoil or thin cable.Check your cable and than flash it again.
Good luck,
Ronald.

TheEckoMan · 07-13-2001, 03:32

Ey ron_baxter !
I had the exact problem with a T10!
U have to use ER2000 or ER2001, it will read the phone even if it does not power on. Then just flash it and it will work 100 % !!!
N e promblems contact me!

07-08-2001, 03:30	#1 (permalink)
ron_baxter Junior Member Join Date: Jun 2001 Location: Scotland Posts: 9 Member: 5071 Status: Offline Thanks Meter: 0	t10 power on problem i can't get my t10 to power on after a flash basically the phone is connected but everything i use times out

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
7610 power on problem no power on with power touch	shani72	Nokia Hardware & Hardware Repair	2	09-10-2008 05:51
Ericsson T10 Power on problem	Xanga	Sony Ericsson Hardware Repair	7	06-25-2003 14:08
Alcatel 511 clock and pinout...power on problem	sigkill	Alcatel TCL Hardware Repair	0	11-12-2001 21:35
m3188 power on problem	sigkill	Motorola Old Legacy (EMMI)	0	08-22-2001 12:25
Trium power on problem When not charging	Pat UK	Mitsubishi	0	07-14-2001 01:44

07-08-2001, 11:32	#2 (permalink)
volcan Insane Poster Join Date: Apr 2001 Location: Netherland Posts: 61 Member: 3993 Status: Offline Thanks Meter: 0	try to flash with Ne121, or datex

07-12-2001, 22:32	#3 (permalink)
ronkor2000 Freak Poster Join Date: Jun 2001 Location: the Netherlands Posts: 197 Member: 4980 Status: Offline Thanks Meter: 3	What prog did you use to flash it? If you use ATR, pin 5 and 6 have to be bridged, standard datacables don't have this. You can bridge it yourself with a piece of alufoil or thin cable.Check your cable and than flash it again. Good luck, Ronald.

07-13-2001, 03:32	#4 (permalink)
TheEckoMan No Life Poster Join Date: Mar 2001 Location: Australia, Melbourne Age: 37 Posts: 548 Member: 3902 Status: Offline Thanks Meter: 19	Ey ron_baxter ! I had the exact problem with a T10! U have to use ER2000 or ER2001, it will read the phone even if it does not power on. Then just flash it and it will work 100 % !!! N e promblems contact me!