Cable M600 -> suitable for J700?

[milenjs]

Hello, I found RJ45 cable with label Sam M600. Is it possible to use with Samsung J700 or needs some modifications?
I try to repair frozen phone but cannot enter in TAT mode with this cable.

[gsm st]

u use samsung d880.d780,e210.j700.to maney pcs cable is same
put battry comming tat mode

[Odia The Ultimate]

Originally Posted by milenjs

Hello, I found RJ45 cable with label Sam M600. Is it possible to use with Samsung J700 or needs some modifications?
I try to repair frozen phone but cannot enter in TAT mode with this cable.

Why not do this?

Select model M600, check what cable type is written
Select model J700, check what cable type is written

if the cable name match, then they must be same
if the cable name does not match, then they must be different

Odia.

[.:GSM International:.]

Originally Posted by Odia The Ultimate

Why not do this?

Select model M600, check what cable type is written
Select model J700, check what cable type is written

if the cable name match, then they must be same
if the cable name does not match, then they must be different

Odia.

Cos Odia, that would require EFFORT from users, and you of all ppl should know that there is a running pattern of lazy ppl here who want us to do it all for them, even press the buttons whilst they sit back and reap the benefit!

[milenjs]

OK, cable is same - NM-20, BUT -> i flash successful J700 but phone still not enter in TAT mode and freeze on Samsung logo (this is problem, may be is hardware). Write EEP or what?
I see on support NM-20 cable schematic - they are switch between TAT and flash mode. Make this modification or not?
Sorry for bad English and thank you

[Odia The Ultimate]

Originally Posted by milenjs

i flash successful J700 but phone still not enter in TAT mode and freeze on Samsung logo (this is problem, may be is hardware). Write EEP or what?

If you read around this subforum you will see that writing the E2P should fix this issue, unless its an hardware fault.

Originally Posted by milenjs

I see on support NM-20 cable schematic - they are switch between TAT and flash mode. Make this modification or not?

It depends if you really want to enter TAT mode then modifying the cable will help.

Odia.