My 201x Hardware Problem Perm. Blockiet

[Mansoor]

Please could put here the correct procedure of repairing that problem have and does it cost credit to do that problem????????????????

[latigido]

@Mansoor
Do you see Hardware failure (Simlock timer) in Repair settings of SagemDD?
Use it. It`s free of charge.

[Mansoor]

Originally Posted by latigido

@Mansoor
Do you see Hardware failure (Simlock timer) in Repair settings of SagemDD?
Use it. It`s free of charge.

Thanks Brother which cable to use???????????

[Oxo_Boxo]

Originally Posted by Mansoor

Thanks Brother which cable to use???????????

Open phone and solder 4 wires (look in TP picture from support).

[Mansoor]

Originally Posted by Oxo_Boxo

Open phone and solder 4 wires (look in TP picture from support).

But thier is no diagram for 201x in the support area

[latigido]

@Mansoor

Are you sure?
Look my100X/my200X .
TP for (my100X, my101X, my200X, my201X, my202X).

[Mansoor]

Originally Posted by latigido

@Mansoor

Are you sure?
Look my100X/my200X .
TP for (my100X, my101X, my200X, my201X, my202X).

My Boss thier is no such tp in the suppory as above and that one which look like my100x has only 5tp to be soldered on but i was told that you have to soldered the whole 7 pin on the phone if possible put the tp on here with seven pins to be soldered on the board thanks

[latigido]

@Mansoor
Solder 4 wires and connect C-2 connector.
Oxo_Boxo gave you recommendation about my501X. Sometimes anyone does the mistake.