My C4 TP - GSM-Forum

cpu486 · 05-06-2008, 17:44

I accidentally damaged TP adapter for unlocking MY C4 and now I have to re solder it again.
Can anybody tell me where I should connect RX, TX and gnd?
Any schematic (beside (MyC4_C5w_S7_WonuS1_TP.jpg from support - no rx, tx shown on test point)?

Thanks in advance.

Oxo_Boxo · 05-06-2008, 19:52

This phone have system connector - use data cable myC-2 type.
Not need to solder Rx/Tx/Gnd to phone pcb.

05-06-2008, 17:44	#1 (permalink)
cpu486 No Life Poster Join Date: Mar 2001 Location: Europe Posts: 561 Member: 3918 Status: Offline Thanks Meter: 15	My C4 TP I accidentally damaged TP adapter for unlocking MY C4 and now I have to re solder it again. Can anybody tell me where I should connect RX, TX and gnd? Any schematic (beside (MyC4_C5w_S7_WonuS1_TP.jpg from support - no rx, tx shown on test point)? Thanks in advance.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How yo connect 5V Power Supply to MY-C4 TP ?	tical	SagMaster Team OLD Products	7	06-18-2005 00:01
SCDRII My-C4 TP JIG does NOT fit My-C4!!! HELP!	crusher	SagMaster Team OLD Products	2	04-20-2005 00:26
My-C3, My-C4, My-C5w Unlock Solution	blackmatrix	ARM9 BASED M62 / M62+	0	01-23-2005 17:25
My-C4 unlock	SJS	FuriouS II	2	10-11-2004 13:45
my-c4 unlock	SJS	ARM9 BASED M62 / M62+	9	10-05-2004 14:07

05-06-2008, 19:52	#2 (permalink)
Oxo_Boxo No Life Poster Join Date: Jun 2002 Location: East Europe Age: 51 Posts: 3,950 Member: 12837 Status: Offline Thanks Meter: 2,740	This phone have system connector - use data cable myC-2 type. Not need to solder Rx/Tx/Gnd to phone pcb.