v3xx dead - GSM-Forum

mobileservises · 11-01-2007, 16:24

i have v3xx it dead first on front red light glow automatly and the it was dead now when i insert battery it heat u any soul

TNEKJIAN · 11-30-2007, 17:35

*Use smartclip and smart TP*

**Please ensure that LCD is disconnected from the board
**Connect smart Testpoint cable to the port RJ45 on smart-clip
**connect data cable to the phone
**Connect battery hook to the possitive+ Battery contact on PCB
**open smart moto
**open prepare phone
**select model phone
**select prepare phone
**when receive the message for TP
**Connect needle A to the testpoint A and hold it until the software informs that it can be disconnected
** THE PHONE ITS UNLOCKING & REPARE **

TNEKJIAN · 11-30-2007, 18:51

testpoint A cable its yellow

11-01-2007, 16:24	#1 (permalink)
mobileservises Junior Member Join Date: Aug 2007 Posts: 32 Member: 568395 Status: Offline Thanks Meter: 3	v3xx dead i have v3xx it dead first on front red light glow automatly and the it was dead now when i insert battery it heat u any soul

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
v3xx dead after smart...	arammob	Motorola P2k	8	10-08-2009 15:56
Bad V3xx DEAD DEAD	5rrrrr	Smart-Clip	8	01-31-2008 08:35
V3xx dead!	manistar	Smart-Clip	13	10-19-2007 05:50
v3xx dead..	Mang mel	Smart-Clip	1	10-09-2007 12:07
v3xx dead no BOOTLOADER MODE can ALIVE with SC + TP??	blue_life1111	Smart-Clip	7	10-01-2007 16:06

11-30-2007, 17:35	#2 (permalink)
TNEKJIAN Major Poster Join Date: Jan 2005 Age: 47 Posts: 42 Member: 103475 Status: Offline Thanks Meter: 0	Use smartclip and smart TP Please ensure that LCD is disconnected from the board Connect smart Testpoint cable to the port RJ45 on smart-clip connect data cable to the phone Connect battery hook to the possitive+ Battery contact on PCB open smart moto open prepare phone select model phone select prepare phone when receive the message for TP Connect needle A to the testpoint A and hold it until the software informs that it can be disconnected THE PHONE ITS UNLOCKING & REPARE

11-30-2007, 18:51	#3 (permalink)
TNEKJIAN Major Poster Join Date: Jan 2005 Age: 47 Posts: 42 Member: 103475 Status: Offline Thanks Meter: 0	testpoint A cable its yellow