c45 card error - GSM-Forum

GSM RAJ · 03-04-2004, 18:53

c45 when turns on without sim shows 'card error'.

abdoune · 03-08-2004, 12:27

Hallo, with the proggy Freia build 9 ,create map from phone and put the original IMEI click Ok and power on the phone....
Salam

**Victor** · 03-08-2004, 13:15

Problem is absolutely hardware:

Vcc pin on card are set to GND and phone display "Card error" without card.

Get board and put back side with antena up. Lower right pin on simcard connector is VCC. Check if is on GND check before this pin have diode group (small element with 6 pins). after this have capacitors to GND. Check them. if is ok move board with antenqa to left. Remove Dialog chip and check from right to left 3 rd pin if is on GND.

03-04-2004, 18:53	#1 (permalink)
GSM RAJ No Life Poster Join Date: May 2001 Posts: 1,046 Member: 4600 Status: Offline Thanks: 129 Thanked 62 Times in 36 Posts	c45 card error c45 when turns on without sim shows 'card error'.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
thread	Thread Starter	Forum	Replies	Last Post
Card error 13 and card read error	smp_comms	MT-BOX	0	02-04-2009 13:37
Card error 13 and card read error	smp_comms	BB5 Box by D.K.	0	02-04-2009 11:51
a parfect solution for c45/a50 error card	fethi	x1x to x45/x50	0	06-09-2007 16:22
S35 Card error without sim card....	questman	Siemens Hardware Repair Area	0	07-29-2002 19:39
C45 Flash error	perreau	x1x to x45/x50	10	01-10-2002 14:07

03-08-2004, 12:27	#2 (permalink)
abdoune No Life Poster Join Date: Feb 2004 Location: Algeria Posts: 2,078 Member: 56090 Status: Offline Thanks: 33 Thanked 98 Times in 46 Posts	Hallo, with the proggy Freia build 9 ,create map from phone and put the original IMEI click Ok and power on the phone.... Salam

03-08-2004, 13:15	#3 (permalink)
Victor Moderator Join Date: May 1999 Location: Blagoevgrad, Bulgaria Age: 41 Posts: 627 Member: 73 Status: Offline Sonork: 100.86913 Thanks: 5 Thanked 304 Times in 92 Posts	Problem is absolutely hardware: Vcc pin on card are set to GND and phone display "Card error" without card. Get board and put back side with antena up. Lower right pin on simcard connector is VCC. Check if is on GND check before this pin have diode group (small element with 6 pins). after this have capacitors to GND. Check them. if is ok move board with antenqa to left. Remove Dialog chip and check from right to left 3 rd pin if is on GND.