Siemens C25 dead solution after wrong flashing
 

http://homepages.atnet.ru/anry/index.htm

Andrey
[email protected]

I have C25 v 61 DEAD after partial flash...
and I don't write full v51 *c2r error error error....


GOOD solution please...

-=G3=-

Guys!! You as little scoolboys...You cant flash c25 with v61 to lower version...forget it...This solution for idiots and lamers becouse man who write it newer see c25 v 61...
WBR.
Peter

solution not for c25 v61
 

solution not for c25 v61, solutoin for c25 old version killed by swup v61......

no way

I think it's better dont touch C25 V.61, because there is No Solution for dead phone C25 V.61, or some one have solution for this case?

B.R

Hendut

Hardware metod worked good at this model
:-)
Repair time is 15Min per phone :-(;)

HFP All its humanly possible )

HFP -> Men who make no conscience of a lie, do yet take some bog at an oath.

Hi! I have a problem. I have c25 and I dont know which
version it was. Some "unlockers" played with it.

Phone was dead. I flashed it with 4804 soft.
Now it can write "SERVICE MODE" but it cann't be switch ON.
Bartek writes that it is 48 version and
IMEI is 000000000000
Eeprom looks like all zerros but there are some data.

Is it possible to find somewhere eeprom for this piece?
Or how to repair? Thankx!

Now this possible via cable.......
wbr.
Peter

Jonwillow...........
Can u send me the picture of replacing the resistor please as i lost mine somewhere........i didnt used it a long time ago and now i need it again.......
Thanx........

[email protected]
[email protected]

@Jonwillow

mail me too with your human solution :) please...........

[email protected]