Repair ALL SX1 here - GSM-Forum

**BB-gsm** · 04-19-2006, 18:15

Hey everybody !

Here`s my next guide about Siemens reviving, now about this crazzzyyy SX1 !!!

REPAIR ALL software Bugs of SX1, not going in SWUP mode, blinking, not turning on, dead .. etc

Tools needed:
Software: V-Klay v3.3, Joker v3.4.3, SYMBIAN FULL Flash file 32Mb (with loader for V-Klay), E-Gold FullFlash 8Mb
Hardware: ANY S-Gold based x65/75 phone (with 32Mb flash chip)

There are 2 types of SX1:

One has BIG FlashIC, second has SMALL as ANY S-Gold x65 phones with 32Mb !
For example, let`s say, we have SX1 with BIG Flash IC and a working C65 phone;

So what you have to do is to put a SMALL FlashIC in this C65, as SX1 has BIG one it will not fit in C65 board, so you`ll need a SMALL flashIC from any x65 S-Gold phone (C65, CX65, ..etc)

So now we have to Write a SX1 Symbian FLASH part in it

Copy provided loader x65pv.vkd into V-Klay`s loader folder(V_KLay\data\Loaders), And open up V-Klay !
Choose options like this:

Thus, open Symbian FullFlash and press write memory (new window will come up asking if you really want to write fullflash, just press YES)
So, Connect TestPoint with GROUND and power on the phone shortly,

boot.bin will go, and you`ll hear a BEEP sound, soft saying Pause.bin, now you have to DISCONNECT TestPoint from ground, Software will boot and start prepairing to READ BACKUP, so just cancel it, then it will START WRITING Fullflash ...

In about a half an hour (depends what speed you are writting full with), it will say Flashing Completed Successfully !!!

Now take out the FLASH IC from C65 and put it in SX1 OMAP board, (reball it and resolder as well

)

See the balls which you will IGNORE

After you have Resoldered it well, replace these 2 resistors and short the rest two

You can see well in this picture:

Symbian Flash is DONE !

What about E-Gold part ?!

Now open up Joker, and Fullflash the phone with 8Mb fullflash, make recalc all keys after flashing as usual !

AND POWER UP SX1 !!!!

Damn this crazzzyyyy SX1 is working now !!!

web-site access:
User: GEORGIA
Pass: Tbilisi

Password of protected files is: Tbilisi

Very BIG thanks to my friend DJON (vladvil) for helping

Regards,
BB-gsm

boneksl · 04-19-2006, 20:26

Yes 100% work,i use this metod in 2005year :-)
but solution give me my friend... i canot write to any forum

... but now 100% oficial!

BR

dragories · 04-20-2006, 11:25

very hard solution, software and hardware combinations.. not for newbie.

club gsm · 04-20-2006, 11:28

i have 2 sx1 not going in test mode ?

help pls

FullFLASHgSMPH · 04-23-2006, 12:19

Nice I Will Try..................

hallo · 04-24-2006, 09:33

...I have here one SX1 wich come to me one month before, I do WinSwup and phone working OK untill now. Now only SiemensMobile at the startup...I can flash hem with any tool, WinSwup goes just fine but result is the same...only SiemensMobile....??????

**BB-gsm** · 04-24-2006, 10:03

@ hallo

Press and hold buttons:

Code:

 * + # + Power On

You`ll see =============== on screen (Formatting)

Battery must be well charged of course !

Regards,
B

hallo · 04-24-2006, 12:19

Quote:

Originally Posted by BB-gsm

@ hallo

Press and hold buttons:

Code:

 * + # + Power On

You`ll see =============== on screen (Formatting)

Battery must be well charged of course !

Regards,
B

..interesting...but I try that allredy....strang thing that nothing is hapening when I try to make Format by thewse way...propobli is some trouble with keyboard, but for now I'm waiting for *******r authorazition to move further...

**BB-gsm** · 04-24-2006, 12:35

@ hallo

Have you tried to plug in charger to the powered off phone ?

hallo · 04-25-2006, 08:20

Quote:

Originally Posted by BB-gsm

@ hallo

Have you tried to plug in charger to the powered off phone ?

...I try to do that also...battery is charging but on display only SiemensMobile...nmothing more.

**BB-gsm** · 04-25-2006, 09:18

If it can go to Flash mode, and it can be flashed (with swup v15, via USB) with all options ticked but result is same, it means it is hardware problem, try rehoting RAM IC and then CPU !

Regards,
B

ryumahon · 04-25-2006, 09:52

holy smoke!! finally a solution for sx1!!!!! thnks so much!!!!

bok_46 · 04-25-2006, 10:19

thanx to nice solution keep up....

kiriazy · 04-26-2006, 09:58

nice soliution but i don't have any S-Gold phone in hand & i think that my problem is the symbian part so is there any other sugestions ?

i need wuick help please

BR,

Kiriazy

kaaniletisim · 04-26-2006, 10:49

thx sır test me ok thx

04-19-2006, 18:15	#1 (permalink)
BB-gsm Moderator Join Date: Jul 2004 Location: GEORGIA,Tbilisi Posts: 3,266 Member: 75765 Status: Offline Thanks: 0 Thanked 481 Times in 67 Posts	Repair ALL SX1 here Hey everybody ! Here`s my next guide about Siemens reviving, now about this crazzzyyy SX1 !!! REPAIR ALL software Bugs of SX1, not going in SWUP mode, blinking, not turning on, dead .. etc Tools needed: Software: V-Klay v3.3, Joker v3.4.3, SYMBIAN FULL Flash file 32Mb (with loader for V-Klay), E-Gold FullFlash 8Mb Hardware: ANY S-Gold based x65/75 phone (with 32Mb flash chip) There are 2 types of SX1: One has BIG FlashIC, second has SMALL as ANY S-Gold x65 phones with 32Mb ! For example, let`s say, we have SX1 with BIG Flash IC and a working C65 phone; So what you have to do is to put a SMALL FlashIC in this C65, as SX1 has BIG one it will not fit in C65 board, so you`ll need a SMALL flashIC from any x65 S-Gold phone (C65, CX65, ..etc) So now we have to Write a SX1 Symbian FLASH part in it Copy provided loader x65pv.vkd into V-Klay`s loader folder(V_KLay\data\Loaders), And open up V-Klay ! Choose options like this: Thus, open Symbian FullFlash and press write memory (new window will come up asking if you really want to write fullflash, just press YES) So, Connect TestPoint with GROUND and power on the phone shortly, boot.bin will go, and you`ll hear a BEEP sound, soft saying Pause.bin, now you have to DISCONNECT TestPoint from ground, Software will boot and start prepairing to READ BACKUP, so just cancel it, then it will START WRITING Fullflash ... In about a half an hour (depends what speed you are writting full with), it will say Flashing Completed Successfully !!! Now take out the FLASH IC from C65 and put it in SX1 OMAP board, (reball it and resolder as well ) See the balls which you will IGNORE After you have Resoldered it well, replace these 2 resistors and short the rest two You can see well in this picture: Symbian Flash is DONE ! What about E-Gold part ?! Now open up Joker, and Fullflash the phone with 8Mb fullflash, make recalc all keys after flashing as usual ! AND POWER UP SX1 !!!! Damn this crazzzyyyy SX1 is working now !!! web-site access: User: GEORGIA Pass: Tbilisi Password of protected files is: Tbilisi Very BIG thanks to my friend DJON (vladvil) for helping Regards, BB-gsm

04-24-2006, 09:33	#6 (permalink)
hallo No Life Poster Join Date: Feb 2003 Location: TelServisHalo,Loznica, Serbia Age: 42 Posts: 1,251 Member: 21365 Status: Online Thanks: 29 Thanked 62 Times in 43 Posts	Ok...good solution but... ...I have here one SX1 wich come to me one month before, I do WinSwup and phone working OK untill now. Now only SiemensMobile at the startup...I can flash hem with any tool, WinSwup goes just fine but result is the same...only SiemensMobile....??????

04-24-2006, 10:03	#7 (permalink)
BB-gsm Moderator Join Date: Jul 2004 Location: GEORGIA,Tbilisi Posts: 3,266 Member: 75765 Status: Offline Thanks: 0 Thanked 481 Times in 67 Posts	@ hallo Press and hold buttons: Code: * + # + Power On You`ll see =============== on screen (Formatting) Battery must be well charged of course ! Regards, B

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
thread	Thread Starter	Forum	Replies	Last Post
Repair ALL A65 here ... ;-)	BB-gsm	E-Gold Based Phones	298	07-04-2011 21:06
Repair ALL A70 here	BB-gsm	E-Gold Based Phones	196	09-10-2010 16:39
Repair all alcatel here!!!	libra202	Alcatel TCL Hardware Repair Section	72	05-21-2010 08:42
Repair all A75 here	.::Mystic::.	E-Gold Based Phones	15	01-12-2008 14:10
Repair all CF62 here	.::Mystic::.	E-Gold Based Phones	34	12-01-2007 05:02

04-19-2006, 20:26	#2 (permalink)
boneksl Major Poster Join Date: Dec 2004 Age: 26 Posts: 46 Member: 98744 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	Yes 100% work,i use this metod in 2005year :-) but solution give me my friend... i canot write to any forum ... but now 100% oficial! BR

04-20-2006, 11:25	#3 (permalink)
dragories Freak Poster Join Date: Jan 2002 Location: phils. Posts: 240 Member: 8450 Status: Offline Thanks: 212 Thanked 14 Times in 10 Posts	very hard solution, software and hardware combinations.. not for newbie.

04-20-2006, 11:28	#4 (permalink)
club gsm Freak Poster Join Date: Apr 2005 Posts: 188 Member: 140076 Status: Offline Thanks: 0 Thanked 4 Times in 1 Post	i have 2 sx1 not going in test mode ? help pls

04-23-2006, 12:19	#5 (permalink)
FullFLASHgSMPH Banned Join Date: Jul 2005 Location: Philippines Age: 42 Posts: 4,666 Member: 161739 Status: Offline Sonork: 100.1584054 Thanks: 6,376 Thanked 3,619 Times in 1,014 Posts	Nice I Will Try..................

04-24-2006, 12:35	#9 (permalink)
BB-gsm Moderator Join Date: Jul 2004 Location: GEORGIA,Tbilisi Posts: 3,266 Member: 75765 Status: Offline Thanks: 0 Thanked 481 Times in 67 Posts	@ hallo Have you tried to plug in charger to the powered off phone ?

04-25-2006, 09:18	#11 (permalink)
BB-gsm Moderator Join Date: Jul 2004 Location: GEORGIA,Tbilisi Posts: 3,266 Member: 75765 Status: Offline Thanks: 0 Thanked 481 Times in 67 Posts	If it can go to Flash mode, and it can be flashed (with swup v15, via USB) with all options ticked but result is same, it means it is hardware problem, try rehoting RAM IC and then CPU ! Regards, B

04-25-2006, 09:52	#12 (permalink)
ryumahon No Life Poster Join Date: Apr 2001 Location: Sun Age: 34 Posts: 2,788 Member: 4021 Status: Offline Thanks: 832 Thanked 807 Times in 348 Posts	holy smoke!! finally a solution for sx1!!!!! thnks so much!!!!

04-25-2006, 10:19	#13 (permalink)
bok_46 No Life Poster Join Date: Jul 2005 Location: Hidden Leaf Village Age: 33 Posts: 576 Member: 165559 Status: Offline Thanks: 428 Thanked 24 Times in 21 Posts	thanx to nice solution keep up....

04-26-2006, 09:58	#14 (permalink)
kiriazy No Life Poster Join Date: Jan 2004 Location: faraway from heaven Age: 30 Posts: 595 Member: 50456 Status: Offline Thanks: 1 Thanked 1 Time in 1 Post	nice soliution but i don't have any S-Gold phone in hand & i think that my problem is the symbian part so is there any other sugestions ? i need wuick help please BR, Kiriazy

04-26-2006, 10:49	#15 (permalink)
kaaniletisim No Life Poster Join Date: Aug 2004 Location: ==TÜRKİYE== Age: 38 Posts: 868 Member: 79065 Status: Offline Sonork: 1577556 Thanks: 2,736 Thanked 57 Times in 48 Posts	thx sır test me ok thx