7610 dead,flashing ok,still dead - GSM-Forum

Vcell · 08-04-2008, 05:06

my 7610 was dead because water damage.i've flash with nbox.flashing ok until finish,but cannot UIi settingand the phone still dead..any solution ??please help sir...thanks

mobilelink · 08-04-2008, 06:02

Mate

According to what u say ..at the 1st stage ur phone waz dead due to liquid damge which is a harware issue

But now it seems to n coz of the firmware virsion u have flashed
(May b)

Solution

01 - First make sure Ur PCB is clean an d no short..(Chk with th emulti meter)
02- Flash with the latest version of it and write a good Pm and unlock )...after doing UI settings if ok ..INI NORMAL MODE..if ok DONE

Post results

BR

Baby Rain · 08-10-2008, 11:57

sir try to erase files... then flash it with the higher version.... Hope it can help...

You can do it!!!!

08-04-2008, 05:06	#1 (permalink)
Vcell Junior Member Join Date: Nov 2007 Location: Indonesia Posts: 5 Member: 641316 Status: Offline Thanks Meter: 3	7610 dead,flashing ok,still dead my 7610 was dead because water damage.i've flash with nbox.flashing ok until finish,but cannot UIi settingand the phone still dead..any solution ??please help sir...thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
6610 Dead-flashing Ok-still Dead	zonetrichur	Nokia Hardware & Hardware Repair	14	02-03-2007 17:09
Sgh E600 Dead-flashing Ok-still Dead	zonetrichur	Trident/AGERE Platform	6	01-06-2007 15:48
2600 flashing ok-still dead	zonetrichur	MT-BOX	3	11-30-2006 18:48
6630 Dead-flashing Ok-still Dead	zonetrichur	Nokia Hardware & Hardware Repair	4	11-22-2006 05:54
6610 Dead-flashing Ok-still Dead	zonetrichur	UFS2 + UFS3-Tornadoflasher	6	09-20-2006 12:27

08-04-2008, 06:02	#2 (permalink)
mobilelink No Life Poster Join Date: Jul 2006 Location: UK Age: 45 Posts: 532 Member: 318277 Status: Offline Thanks Meter: 92	Mate According to what u say ..at the 1st stage ur phone waz dead due to liquid damge which is a harware issue But now it seems to n coz of the firmware virsion u have flashed (May b) Solution 01 - First make sure Ur PCB is clean an d no short..(Chk with th emulti meter) 02- Flash with the latest version of it and write a good Pm and unlock )...after doing UI settings if ok ..INI NORMAL MODE..if ok DONE Post results BR

08-10-2008, 11:57	#3 (permalink)
Baby Rain Junior Member Join Date: Jul 2006 Location: Caloocan Phils. Age: 46 Posts: 17 Member: 322319 Status: Offline Thanks Meter: 4	sir try to erase files... then flash it with the higher version.... Hope it can help... You can do it!!!!