DC power supply ? - GSM-Forum

Jojo83 · 02-15-2017, 21:37

Hi, i can't buy a DC power supply, but i have a soldeing station with hot air with Volt/amp test
3 in 1 station.

I can use in DC power supply with this machine ? for test motherboard iphone ?

i can't post picture but i have Baku station 3 in 1 (i put on output or on "test" ?) u can see the picture on web.

Because i want to test "volt" and amp" in the motherboard for check short.
I'am newbie...
Tanks !!

fulviospano · 02-16-2017, 00:34

Is you can use it, even if 1 A of current is little, if you want to power the motherboard you have to put the switch on OUTPUT and set the voltage to 4.2 V, if you put the switch on TEST measure the voltage.

Jojo83 · 02-16-2017, 03:57

Ok thanks, and if i want test , i switch on test but i put volt on 0 ?

fulviospano · 02-16-2017, 16:21

it does not matter because the connectors to measure the voltage are the two to the right under the word TEST

02-15-2017, 21:37	#1 (permalink)
Jojo83 Freak Poster Join Date: Feb 2017 Location: Earth Posts: 207 Member: 2681768 Status: Offline Thanks Meter: 30	DC power supply ? Hi, i can't buy a DC power supply, but i have a soldeing station with hot air with Volt/amp test 3 in 1 station. I can use in DC power supply with this machine ? for test motherboard iphone ? i can't post picture but i have Baku station 3 in 1 (i put on output or on "test" ?) u can see the picture on web. Because i want to test "volt" and amp" in the motherboard for check short. I'am newbie... Tanks !!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-16-2017, 00:34	#2 (permalink)
fulviospano Freak Poster Join Date: Aug 2005 Location: Italy Age: 49 Posts: 121 Member: 168904 Status: Offline Thanks Meter: 23	Is you can use it, even if 1 A of current is little, if you want to power the motherboard you have to put the switch on OUTPUT and set the voltage to 4.2 V, if you put the switch on TEST measure the voltage.

02-16-2017, 03:57	#3 (permalink)
Jojo83 Freak Poster Join Date: Feb 2017 Location: Earth Posts: 207 Member: 2681768 Status: Offline Thanks Meter: 30	Ok thanks, and if i want test , i switch on test but i put volt on 0 ?

02-16-2017, 16:21	#4 (permalink)
fulviospano Freak Poster Join Date: Aug 2005 Location: Italy Age: 49 Posts: 121 Member: 168904 Status: Offline Thanks Meter: 23	it does not matter because the connectors to measure the voltage are the two to the right under the word TEST