Complete GD35 Pinout Here!

[X-Shadow]

Hello Guys,<br />Back of phone under the battery you will see...

[ 2o 4o [-][=][+] ]<br />[ 1o 3o ]

1 - is External power input <br /> - Put 5V and the phone will start Charging<br />2 - AGND<br /> - Can be used for Data Cable GND<br />3 - RX of phone<br /> - Put TX of Data cable here<br />4 - TX of phone<br /> - Put RX of Data cable here

[-] - Battery GND Pin<br /> - Can be used for Data Cable GND<br />[=] - Also connected to Batt GND<br />[+] - Battery Voltage Input 3.6v 700mAh

To make a data cable, use GD52/92/93 data cable<br />schematics <img src="smile.gif" border="0"> You do not need to short any pins.<br />Follow scheme from <a href="http://www.gsmhacking.com" target="_blank">www.gsmhacking.com</a> or from <br />picture in this forum!

I tested the Data Cable I built with Winmodo and<br />GD53 LP. Off course Winmodo did NOTflash the phone<br />with the GD52 language pack, but it was able to<br />put it into Flash Mode... Test also with Jethro<br />soft for GD52, but when soft says <br />"Not GD52 Continue?" NEVER NEVER click OK because<br />you will end up with DEAD phone <img src="frown.gif" border="0"> Just exit the<br />program and everything will be ok <img src="smile.gif" border="0">

If anyone here have flash files for GD35 for <br />WinMoDo, please email me ...

[email protected]

Best Regards,<br />X-Shadow

<FONT COLOR="#ffff00" SIZE="1">[ 14 December 2001 22:02: Message edited by: X-Shadow ]</font>