Save GD50 - GSM-Forum

sherifa · 10-05-2000, 14:57

Please who can help me to flash or save my PAn GD50.

After I try to unlock with GD50-GD30 repair/unlock tool by Viknet. my phone dead. I can not put it on again.

Who has the solution ?

Gsm Trade · 10-19-2000, 19:43

Hello!!!

I have same problem but i was fix it with Viknet again. Charge baterry and try agian.
You must try many times. If your phone goes in test mode than is ok .

Here are instructions:.RUN program "GD50 repair&unlock by viknet v1.0 "
(program attached..)
2.press "set test mode" and ON phone..phone goes test mode..
you will see IMEI and SERIAL..you can enter any ...
for example
IMEI : 555555555555555
SERIAL:IIIIIIIIIIIIII
3. press "Repair and Unlock"
you will see again warning message..

repeat this steps Until you see

IMEI: FFFFFFFFFFFFFF0
SERIAL:yyyyyyyyyyyy

that is very important..
at this point you will enter

IMEI : 449121882548521
SERIAL : 125005687236501 ( not magic numbers just fit)

and press "Repair and Unlock"
phoen lights will up..and nothing on the screen..
press keys..and lights still ON..
keep about 2-3 minutes of this position..
(keep pressing keypad,linghts ON and nothing on the screen..)
4. after 2-3 minutes OFF the phone and ON again..THAT'S ALL..

------------------
Best Regards
Greetings from Slovenia
gsm.trade@email.si

10-05-2000, 14:57	#1 (permalink)
sherifa Junior Member Join Date: Aug 2000 Posts: 5 Member: 1930 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	Save GD50 Please who can help me to flash or save my PAn GD50. After I try to unlock with GD50-GD30 repair/unlock tool by Viknet. my phone dead. I can not put it on again. Who has the solution ?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
thread	Thread Starter	Forum	Replies	Last Post
Save Energy to Stop Global Warming and to Save our EARTH !!!	SinghForHelp	MXKEY Nokia Flasher and Unlocker (by Alim Hape)	9	03-19-2010 18:46
6280 chargshow ok but not save charg save batry	ahmedbarra	Nokia Hardware & Hardware-Repair Area	6	02-14-2010 18:06
Saved or not Saved number .	dynamic-gsm	GSM Programming & Reverse Engineering	0	08-23-2007 12:14
gd50 chbxs	ARt	Panasonic	0	03-22-2000 10:27
dead gd50	ARt	Panasonic	0	03-13-2000 09:38

10-19-2000, 19:43	#2 (permalink)
Gsm Trade Major Poster Join Date: Oct 2000 Location: Slovenia Posts: 40 Member: 2326 Status: Offline Thanks: 0 Thanked 0 Times in 0 Posts	Hello!!! I have same problem but i was fix it with Viknet again. Charge baterry and try agian. You must try many times. If your phone goes in test mode than is ok . Here are instructions:.RUN program "GD50 repair&unlock by viknet v1.0 " (program attached..) 2.press "set test mode" and ON phone..phone goes test mode.. you will see IMEI and SERIAL..you can enter any ... for example IMEI : 555555555555555 SERIAL:IIIIIIIIIIIIII 3. press "Repair and Unlock" you will see again warning message.. repeat this steps Until you see IMEI: FFFFFFFFFFFFFF0 SERIAL:yyyyyyyyyyyy that is very important.. at this point you will enter IMEI : 449121882548521 SERIAL : 125005687236501 ( not magic numbers just fit) and press "Repair and Unlock" phoen lights will up..and nothing on the screen.. press keys..and lights still ON.. keep about 2-3 minutes of this position.. (keep pressing keypad,linghts ON and nothing on the screen..) 4. after 2-3 minutes OFF the phone and ON again..THAT'S ALL.. ------------------ Best Regards Greetings from Slovenia gsm.trade@email.si