6680 Black Pfo To Replace-how Much The Temperature? - GSM-Forum

zonetrichur · 10-03-2007, 18:36

Hi,
I Purchased Ir Station Last Week.so Have Not Experience.black Colour Pfo's In 1100,6680 Dmamaged When Using Ordinary Hot Air Guns-so I Purchased Infrared Station.
But Did Not See Note For Temperature Settings.how Much Temperature Set For Preheater And Handheld Unit To Replace 6680 Pfo?

Thank U

ASK_ME · 12-12-2007, 09:11

็Hi
That I Know,normal lead melt temp about 150-160 C ,and lead-free melt temp abot 210-220 C,and new phone use lead-free ,I think you must hot PCB to 220 C.

ASK_ME · 12-12-2007, 09:28

See pix below,I take from Sony-ericsson service manual,may can help you.

chiragsp_codes · 12-12-2007, 09:41

@zone

500 to preheater and and after pre-heater reach to 500 start handle at 200 or 300 to replace ur pf

thanks

10-03-2007, 18:36	#1 (permalink)
zonetrichur No Life Poster Join Date: Mar 2006 Location: india Posts: 1,395 Member: 239168 Status: Offline Thanks Meter: 104	6680 Black Pfo To Replace-how Much The Temperature? Hi, I Purchased Ir Station Last Week.so Have Not Experience.black Colour Pfo's In 1100,6680 Dmamaged When Using Ordinary Hot Air Guns-so I Purchased Infrared Station. But Did Not See Note For Temperature Settings.how Much Temperature Set For Preheater And Handheld Unit To Replace 6680 Pfo? Thank U

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to check how much log/credit left on micro??	khem	Basic Micro-Box Software Support (SAMSUNG, HUAWEI, etc...)	2	04-01-2009 00:15
How much credits will it cost to flash myx6-2 phone with flash same as in the phone?	timitron	SMTi	13	04-16-2008 07:23
How much time to have the code	morton	UnlockBase	3	11-25-2007 00:33
how much the price of nokia lcd in your country	nimanima	Nokia Hardware & Hardware Repair	1	11-16-2007 12:39

12-12-2007, 09:11	#2 (permalink)
ASK_ME Freak Poster Join Date: May 2003 Location: Thailand Age: 48 Posts: 125 Member: 30140 Status: Offline Thanks Meter: 17	็Hi That I Know,normal lead melt temp about 150-160 C ,and lead-free melt temp abot 210-220 C,and new phone use lead-free ,I think you must hot PCB to 220 C.

12-12-2007, 09:41	#4 (permalink)
chiragsp_codes Insane Poster Join Date: Oct 2007 Posts: 75 Member: 612091 Status: Offline Thanks Meter: 44	@zone 500 to preheater and and after pre-heater reach to 500 start handle at 200 or 300 to replace ur pf thanks