;;Procedure of Bypassing Activation screen in Palm Pre;;

[uqbah]

All credit goes to GsmFather's team and Their great manual about it.

1-Download WebOs Doctor from here by putting Device serila no.
http://ws.palm.com/webosdoctor/serialnumberinitial.htm



2-
Booting into Recovery Mode
To flash a device with a webOS Doctor or to run the activation-bypass tool, you must first boot the device into recovery mode by performing the following steps:

1.Plug the USB cable into your computer. Do not connect the other end to your device yet.
2.Remove the battery from the device.
3.Hold down the device's volume up button.
4.Insert the USB cable into the device.
5.Re-insert the battery.
6.Release the volume up button.
The device will boot into recovery mode, and you will see the USB logo on the device's screen. At this point, you may run either the webOS Doctor (to flash your device with the latest version of webOS) or the activation-bypass tool (to enable your unactivated device for development).

Run WebOs Docotor and wait for it to finish.
It'll charge battry up to required level before proceeding.So stay relaxed and wait for it to finsih.





3-
Running the Activation-Bypass Tool
The activation-bypass tool is a Java application. To use the tool, you need to have installed Java and the latest webOS SDK (which includes the Novacom driver).

1.Download the activation-bypass tool, which is available here, and save it in the location of your choice.
2.Boot your device into recovery mode, as described above.
3.Run the activation-bypass tool from the command line by issuing the following command: java -jar devicetool.jar
The device will reboot. Once the device is booted, it will be in developer mode, and the first use procedure will not be required. The device will be ready to use, subject to the limitations of non-activation.


Thnks alot to GsmFather team's for good help and manual.
Every thing is there in manual read and follow.
Its just explanation and proof that it works!