***Chinese Hardware section***

[.::skybird::.]

Though there is not exist any Chinese hardware section and may be admins wont to do this. therefore i am going to make this thread as a section where everybody will post those solution who is his 100% tested by him.


and if anyone will use this solution and will got success must post here result

So pls everybody post here just your any tested solution what you had used and got success and try to make up this thread with us.





B.R.
.::skybird::.

[pablos1]

we are still waiting for you to start this thread bro.

[sangar2003]

we are still waiting for you to start this thread also

[.::skybird::.]

1. The thread starter is not just me. you all are the thread starters and should show here all your good experience about Chinese phones hardware.

2. I'll post here my experience and you all will post your exp. Then tomorrow you'll see this thread will be helpful also for you.

3. Now i am going to post my a little experience one by one as soon as possible here and you also will did this with me.

[.::skybird::.]

1. How can i clear the shortage of my Chinese phone?

Here are the two types of shortage but clearing method is same

A. Phone shows shortage without press the power button
B. Phone shows shortage when i press power button.

Open the phone if phone shows the shortage without power then just connect with power supply and Lay your thumb on different components of PCB and Fell which component is getting HOT Remove that component. And if phone shows shortage with pressing the power button then do this process after pressing & hold power button.

2. How can i solve the Insert Sim problem?

After software here are many ways to clear the Insert Sim fault

A. Check Sim connector's pins with meter if anyone not working look forward the pins lines where it goes and make jumper.
B. Resold the sim connectors
C. Change or rehot the Sim ic
D. Some Chinese phones haven't sim ic their sim lines are direct from power ic so rehot or change the power ic.
E. If lines from sim ic to power ic are fine then lines are missing from CPU so rehot or change the CPU.

3. How can i solve the Held problem in hardware?

Some times this problem proves very small As you can see here and some times v. bigg.
After checking these small things you can solve this problem by rehot or change CPU.





As i was said that i'll try to post all my experience as soon one by one as possible so not i'll post letter about all other problems. i hope you'll found this thread v. helpfull and will post also here your own experience.




B.R.
.::Skybird::.