Any news about iPhone 3G preset? - GSM-Forum

wiky · 07-15-2008, 22:42

I hope that we can use the Tornado SIM in the new iPhone 3G in few days...

Please...Test and make the presets!

xileen2k · 07-16-2008, 00:58

yes anybody have locked units, pls test and post presets...

James_S · 07-16-2008, 17:07

I strongly advice you to NOT put TornadoSIM in the iPhone. I did try it, and the card is stuck inside. I have spent an hour trying to get it out now, without success. This is the exact same thing happened when i tried it in a SE K850i.

Before i tried TornadoSIM i tried YesSIM with many different settings, but i didn't get signal on any setting. So i don't think these cards will work. Both Yessim and tornadoSIM bypasses the simlock, getting signal is the problem.

xileen2k · 07-17-2008, 11:00

it depends on how you piggyback the sim with the Tsim inside... better use double adhesive to be safe..

thats what i did before and no problem..

BUt now dont have a iphone 3g yet to test ..

so those who has, pls give it a shot and post results... Thanks.

James_S · 07-17-2008, 17:26

Problem is that even if it works, I would never sell TornadoSIM to customers when there is a risk that it gets stuck like it did with me. I got it out finally (in pieces), but i have many scratches at the top of the phone, and the tray is also little damaged. I'm just lucky the SIM reader still works...

gwaai · 07-18-2008, 20:55

Quote:

Originally Posted by James_S

Problem is that even if it works, I would never sell TornadoSIM to customers when there is a risk that it gets stuck like it did with me. I got it out finally (in pieces), but i have many scratches at the top of the phone, and the tray is also little damaged. I'm just lucky the SIM reader still works...

hee hee .... ME TOO!! damn it ...
i did use double side tape, but it just stuck inside ... i am lucky that the reader also works, but the mechnism that push the SIM Tray is now not working ....

damn damn damn ...

James_S · 07-18-2008, 22:10

Quote:

Originally Posted by gwaai

hee hee .... ME TOO!! damn it ...
i did use double side tape, but it just stuck inside ... i am lucky that the reader also works, but the mechnism that push the SIM Tray is now not working ....

damn damn damn ...

I warned you

I think a solution could be to use tape around the top of the tray, so that the chip is covered with tape. But i'm not going to try that and risk my iphone again.

gwaai · 07-19-2008, 23:26

Quote:

Originally Posted by James_S

I warned you

I think a solution could be to use tape around the top of the tray, so that the chip is covered with tape. But i'm not going to try that and risk my iphone again.

... it happened 1 hours after hat iPhone 3G is on sale in my country .. so i am in same ship with you .... a test-driver ....

i fixed the switch already .... had to make another one, gladly that I was a Dental Technician, so i can duplicate from another iPhone ...

i am going to try another time, since my iPhone is disassembled already, so i am not afraid to be stuck again .... but too busy these days, i will give it a try later when i hv time ...

but same thing here, even it works, i will not sell it too ....

gwaai · 07-20-2008, 01:18

UPDATE:
tested on Rogers iPhone 3G,
I use real MccMnc, got signal on FIDO, can call out, but not receive call, when ppl call, it just seems to be offline, but call out no problem.

gotta go home, try more tomorrow

tested with Real MccMnc, with first tick, Real + 2 ticks, real + 3 ticks ... all same result ...

xileen2k · 07-22-2008, 04:10

great work there friend... keep us updated...

BTW try 2nd box only tick if will work//

THanks.

Go90go · 07-24-2008, 21:09

Quote:

Originally Posted by James_S

I strongly advice you to NOT put TornadoSIM in the iPhone. I did try it, and the card is stuck inside. I have spent an hour trying to get it out now, without success. This is the exact same thing happened when i tried it in a SE K850i.

Before i tried TornadoSIM i tried YesSIM with many different settings, but i didn't get signal on any setting. So i don't think these cards will work. Both Yessim and tornadoSIM bypasses the simlock, getting signal is the problem.

Same **** happened to me, and I destroyed a Tornado SIM and the iPhone's sim tray in removing it. What a piece of ****, this iPhone 3G is turning out to be...

~Cheers~

Celhack · 07-27-2008, 00:11

Allready unlock with t-sim

gwaai · 07-27-2008, 01:07

Quote:

Originally Posted by Celhack

Allready unlock with t-sim

you have many post saying you have solution, and not sharing??

I didn't test with any other provider's iPhone, only TESTED and WORKING with Rogers or FIDO iPhone

[PRESET]
PRESET_NAME = "iPhone 3G"
PRESET_IMSI = "001010123456789"
PRESET_MASK = "111110000000000"
PRESET_FAKE = "10000000000000000000000000000000"

since mySIM doesn't have 3G, so I have to disable 3G option in iPhone, it is under Setting,->Network

if I didn't disable 3G option, i cannot receive call, but call out no problem, when 3G option is disable in iPhone, all is working ... even after 48 hours, still running good ...

don't blame me if not working good, i only tested on FIDO and ROGERS iPhones .... sold many Tornado SIM already, no complain yet ...
Remember, my setting needs to disable 3G in iPhone, if someone has better solution that able to use 3G, use it then ...

Celhack · 07-27-2008, 01:32

Yes is good your post and my way is that, but we don't post until test all functions here in D R.

gwaai · 07-27-2008, 01:33

and again

since iPhone 3G has thinner slot for SIM card, if you put ur SIM and T-SIM together into it, it will be a headache to take it out ...

better way is to:

1. use double side tape to tape the SIM and T-SIM together, especially the TOP and BOTTOM, so it will not bend easily

2. trim you SIM a little bit, so it have an angle at the TOP, so when you wanna take the SIM out, it will not stuck.

3. better way, trim all SIM surface, so it become thinner

07-15-2008, 22:42	#1 (permalink)
wiky Freak Poster Join Date: May 2003 Location: Caribbean Age: 59 Posts: 445 Member: 28074 Status: Offline Thanks: 32 Thanked 11 Times in 11 Posts	Any news about iPhone 3G preset? I hope that we can use the Tornado SIM in the new iPhone 3G in few days... Please...Test and make the presets!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
thread	Thread Starter	Forum	Replies	Last Post
what about A2 modle any news about	wisam_wa	DreamBox	1	04-18-2008 00:32
Any news about T191 ver 1.87 ???	mr_x4you	ODM (Original Design Manufacturing)	0	09-19-2002 21:58
ANY news about MT 50	G$M solution	x1x to x45/x50	0	05-31-2002 06:21
Any news about flashing Micron flash in new L01 Mars	misel	Mitsubishi	5	04-17-2002 01:29
Any news about m3188 ?	SFlood	Old Legacy Motorola (EMMI)	0	09-13-1999 11:12

07-16-2008, 00:58	#2 (permalink)
xileen2k No Life Poster Join Date: Oct 2003 Age: 36 Posts: 737 Member: 41491 Status: Offline Thanks: 18 Thanked 27 Times in 22 Posts	yes anybody have locked units, pls test and post presets...

07-16-2008, 17:07	#3 (permalink)
James_S No Life Poster Join Date: Jan 2005 Age: 43 Posts: 1,727 Member: 105625 Status: Offline Thanks: 10 Thanked 43 Times in 33 Posts	I strongly advice you to NOT put TornadoSIM in the iPhone. I did try it, and the card is stuck inside. I have spent an hour trying to get it out now, without success. This is the exact same thing happened when i tried it in a SE K850i. Before i tried TornadoSIM i tried YesSIM with many different settings, but i didn't get signal on any setting. So i don't think these cards will work. Both Yessim and tornadoSIM bypasses the simlock, getting signal is the problem.

07-17-2008, 11:00	#4 (permalink)
xileen2k No Life Poster Join Date: Oct 2003 Age: 36 Posts: 737 Member: 41491 Status: Offline Thanks: 18 Thanked 27 Times in 22 Posts	it depends on how you piggyback the sim with the Tsim inside... better use double adhesive to be safe.. thats what i did before and no problem.. BUt now dont have a iphone 3g yet to test .. so those who has, pls give it a shot and post results... Thanks.

07-17-2008, 17:26	#5 (permalink)
James_S No Life Poster Join Date: Jan 2005 Age: 43 Posts: 1,727 Member: 105625 Status: Offline Thanks: 10 Thanked 43 Times in 33 Posts	Problem is that even if it works, I would never sell TornadoSIM to customers when there is a risk that it gets stuck like it did with me. I got it out finally (in pieces), but i have many scratches at the top of the phone, and the tray is also little damaged. I'm just lucky the SIM reader still works...

07-20-2008, 01:18	#9 (permalink)
gwaai No Life Poster Join Date: Jan 2004 Age: 34 Posts: 1,364 Member: 49581 Status: Offline Thanks: 23 Thanked 75 Times in 59 Posts	UPDATE: tested on Rogers iPhone 3G, I use real MccMnc, got signal on FIDO, can call out, but not receive call, when ppl call, it just seems to be offline, but call out no problem. gotta go home, try more tomorrow tested with Real MccMnc, with first tick, Real + 2 ticks, real + 3 ticks ... all same result ...

07-22-2008, 04:10	#10 (permalink)
xileen2k No Life Poster Join Date: Oct 2003 Age: 36 Posts: 737 Member: 41491 Status: Offline Thanks: 18 Thanked 27 Times in 22 Posts	great work there friend... keep us updated... BTW try 2nd box only tick if will work// THanks.

07-27-2008, 00:11	#12 (permalink)
Celhack No Life Poster Join Date: Dec 2006 Posts: 1,370 Member: 416710 Status: Offline Thanks: 35 Thanked 347 Times in 178 Posts	Allready unlock with t-sim

07-27-2008, 01:32	#14 (permalink)
Celhack No Life Poster Join Date: Dec 2006 Posts: 1,370 Member: 416710 Status: Offline Thanks: 35 Thanked 347 Times in 178 Posts	Yes is good your post and my way is that, but we don't post until test all functions here in D R.