you can use that method for x10i,x10i,s0-o1b, e10,e15,e16,u20 phones. unlock

[ramcellular]

1.

make sure you have firmware with android 2.x, NOT 1.6.
flash required firmware, if needed.

2.

power on phone without sim card, go to menu->settings->applications->development, enable "usb debugging"
connect phone to PC, install drivers from setool2 distr ( drivers\ADB_Drivers)


3
disable antivirus must and dont detach phone upto 5 min.

4.

select proper phone model.
on settings check signed mode, use alternative security bypass, do full unlock instead usercode reset
press unlock

when prompted, detach phone, turn it on fully, connect it again.
( or you can leave phone on cable, then power it on manually )

when program tells "warming up...", manually power on phone fully, cause it will automatically enter charging mode.

after you see "GETTING ROOT ACCESS ..." DO NOT TOUCH PHONE until procedure complete.




possible problems:

you getting "err: 00000005","err: 00000002" during process.


IF phone not detecting automatically and on status bar you can see "waiting for phone...", again - only in that case - disconnect phone from usb and connect it again, procedure should continue.

if not, well, repeat from start.