Rcdpro 0.0.4.8-Zenec 2000 in support

[Tech mobil]

Rcdpro 0.0.4.8 - Zenec 2000 in support

Latest Update:

- Zenec, ZE-MC2000
- Matsu****a, CQ-VD550W3 DVD

MC2000 decoding goes via reading original dump from processor. Details inside Rcdpro.

Other changes:
- New CLIP Firmware : 02.00.00.03 (automatic update after launch, do not interrupt)
- Added support for SPI and Microwire Memory in Box 2 Plus, and CLIP (Read & Write modes for 8 / 16 bit)
- Added support for SPI serial flash memory (25FL128)
- The ability to read through the interface 4-wires and 3-wires (schematics stored in Programmer bookmark)
- Detection of connected memory for Microwire
- Added ability to put direct links into tool
- Swap Buf. - additional button to swap memory in Dump mode (after use the program again executes the code reading algorithm, this time for inverted bytes)
- Direct Mode is parametrized by Bus speed and Device address
- Added information about the differences in file size, Rcdpro informs what is to be valid
- Added connection diagrams for new protocols directly in the tool
- Programmer tab will store all the possible protocols supported by Clip
- Main menu improvement (works more stable and faster)
- The program remembers the chosen model, you don't need to choose again if dump is bad
- Added option to reload the file from the dump
- Scrollbar in the main menu works as it should and does not move into the void

Tools installer:
http://martech.pl/support/setup_rcdx.exe

Best regards
Martech Team
MARTECH