RIFF JTAG - CDMA Day ! QSC1100, Micromax C111, Huawei C2830 supported

[legija]

06.04.2011 CDMA QUALCOMM QSC1100 Generic DLL released


Resurrector QSC1100 X14 contains only DCC Loader, thus it is to be used only for operations on DCC Read/Write page in the JTAG Manager.
Embedded DCC Loader is designed to work inside of MCU’s internal RAM memory, thus it is not sensitive to external SDRAM configuration or availability or its physical state.


Initial H/W init sequence will setup MCU’s PLL with these parameters:

• Clock Multiplier = 0×14

Since few different versions of QSC1100 resurrector may exist (with different multiplier values) you may select the one which suits best to your device

06.04.2011 CDMA Micromax C111 Boot repair supported


Resurrecting Micromax C111 is simple. Board is auto powered on when battery is inserted and USB cable is connected.
There are 2 different hardware revisions of this phone – one is based on Qualcomm QSC1100 MCU and other – is Qualcomm QSC6010 MCU. Current resurrector shall be selected if you have QSC1100 revision.
Resurrector re-flashes only firmware zone of the phone (0×000000 to 0x6FFFFF).
To resurrect Micromax C111:

• Solder JTAG cable to Micromax C111 JTAG pads;
• Connect ignition cable for auto power on or use battery;
• Make sure Micromax C111 is selected in the list of models;
• Click Resurrect button;
• Wait till software signals a successful operation completion;
• De-solder JTAG wires;

06.04.2011 CDMA Huawei C2830 Boot repair supported


Resurrecting Huawei C2830 is simple. Phone is auto powered on with USB Data Cable connected to the PC. Battery presence is not required; connection can be established with detached board. Since the JTAG test points are placed under keyboard sticker we recommend using USB data cable to supply power to the device.
Resurrector re-flashes only firmware zone of the phone (0×000000 to 0x5FFFFF).
Please note: if you do not have JIG (that is you solder wires instead) then black graphite covering has to be carefully scratched off in order to access copper surface of the pads.


To resurrect Huawei C2830:

• Solder JTAG cable to Huawei C2830 JTAG pads;
• Insert USB Data cable into board and PC;
• Make sure Huawei C2830 is selected in the list of models;
• Click Resurrect button;
• Wait till software signals a successful operation completion;
• De-solder JTAG wires;

Please click “Check For Updates” button in order to download and apply new files. Closing all running application before starting update process is recommended.


RIFF Box – JTAG Revolution