RIFF JTAG - Samsung i607 Blackjack PDA, CDMA Huawei C5005, OMAP 1710 Support added

[legija]

12.03.2011 Samsung SGH-i607 BlackJack PDA Unbrick, Dead Boot repair supported

Resurrecting Samsung i607 PDA part is easy. Phone requires battery presence in order to establish JTAG connection. If you additionally connect charger the phone will be auto powered on and there will be no need to press Power on key.
In case you experience connection problems, de-power phone completely, disconnect charger (if it was used), then insert battery, click Resurrection button in the JTAG Manger and immediately (within 0…1 seconds) press Power On key.
To unbrick Samsung i607 PDA part:

• Solder JTAG cable to Samsung i607 PDA JTAG pads;
• Make sure Samsung i607 PDA is selected in the list of models;
• If only battery is connected – press Power On key shortly;
• Click Resurrect button;
• Wait till software signals a successful operation completion;
• Disconnect power supply, de-solder JTAG wires;

Now phone is in bootable condition, that is, even if it does not start up normally, you can flash it using known flashing methods.

11.03.2011 CDMA Huawei C5005 Unbrick – Repair supported
Resurrecting Huawei C5005 is simple. Phone is auto powered on with USB Data Cable connected to the PC. Battery presence is not required; connection can be established with detached board.
Resurrector re-flashes only firmware zone of the phone (0×000000 to 0xBFFFFF).
To resurrect Huawei C5005:

• Solder JTAG cable to Huawei C5005 JTAG pads;
• Insert USB Data cable into board and PC;
• Make sure Huawei C5005 is selected in the list of models;
• Click Resurrect button;
• Wait till software signals a successful operation completion;
• De-solder JTAG wires;

OMAP 1710 Support added :
OMAP 1710 Specs,
OMAP 1710 based devices.

Please click “Check For Updates” button in order to download and apply new files. Closing all running application before starting update process is recommended.