way to solder back the ripped off ribbon to the digitizer - GSM-Forum

sewkar · 08-01-2011, 18:46

hi i ripped the digitizer flex , from the digitizer when i was opening the torch 9800.
I can see where it must be soldered but i dont know if this is possible...
Is there a way to solder back the ripped off ribbon to the digitizer?
its for a torch 9800 by the way!
thanks
sewkar

radar1 · 08-01-2011, 19:37

Buy a new one.
No other solution.

08-01-2011, 18:46	#1 (permalink)
sewkar Freak Poster Join Date: Apr 2005 Age: 44 Posts: 313 Member: 133351 Status: Offline Thanks Meter: 20	way to solder back the ripped off ribbon to the digitizer hi i ripped the digitizer flex , from the digitizer when i was opening the torch 9800. I can see where it must be soldered but i dont know if this is possible... Is there a way to solder back the ripped off ribbon to the digitizer? its for a torch 9800 by the way! thanks sewkar

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
news headlines to gsm phone	mos	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	7	05-22-2016 11:42
How to add a language in 51xx/61xx	tati	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	8	05-21-2013 19:20
How to upload a new firmware...	Brand	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	8	06-08-2012 18:29
how the **** do i make wintesla 6.03 work	Ravetrancer	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	0	06-16-1999 08:41
Copy from one 6110 to another	Leif Nielsen	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	1	06-10-1999 22:36

08-01-2011, 19:37	#2 (permalink)
radar1 No Life Poster Join Date: Mar 2008 Location: Romania Age: 44 Posts: 770 Member: 724928 Status: Offline Sonork: 100.1581257 Thanks Meter: 225	Buy a new one. No other solution.