how to perform jump - GSM-Forum

dontcareok · 08-23-2010, 19:55

sorry i am completely new and i posted a thread asking for help and someone did but they gave me a diagram of a "jump" but i do not understand how and what to do and i was hoping that someone can explain because i haven't seen a "total newbie faq"

the only jump i know of is of pins covered in a motherboard(bios) or optical drive(master/slave/auto)

much appreciation, thanks

dontcareok · 09-03-2010, 03:23

is this question so complicated that nobody can respond? i'm thinking its done with a piece of copper wire (although i don't know where i would be able to find one so thin, so maybe paperclips would work?) touching the points? and i'm assuming the unit has to be on? but not sure which ribbon (iphone) supplies power to the board

a little help, please?

08-23-2010, 19:55	#1 (permalink)
dontcareok Junior Member Join Date: Aug 2010 Posts: 4 Member: 1376134 Status: Offline Thanks Meter: 0	how to perform jump sorry i am completely new and i posted a thread asking for help and someone did but they gave me a diagram of a "jump" but i do not understand how and what to do and i was hoping that someone can explain because i haven't seen a "total newbie faq" the only jump i know of is of pins covered in a motherboard(bios) or optical drive(master/slave/auto) much appreciation, thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
news headlines to gsm phone	mos	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	7	05-22-2016 11:42
How can I do a Welcome note for my 6110 a dosn't have any one ?	Viper	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	8	06-27-2015 11:57
How to add a language in 51xx/61xx	tati	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	8	05-21-2013 19:20
How to upload a new firmware...	Brand	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	8	06-08-2012 18:29
Copy from one 6110 to another	Leif Nielsen	Nokia Legacy Phones ( DCT-1 ,2 ,3 ,L )	1	06-10-1999 22:36

09-03-2010, 03:23	#2 (permalink)
dontcareok Junior Member Join Date: Aug 2010 Posts: 4 Member: 1376134 Status: Offline Thanks Meter: 0	is this question so complicated that nobody can respond? i'm thinking its done with a piece of copper wire (although i don't know where i would be able to find one so thin, so maybe paperclips would work?) touching the points? and i'm assuming the unit has to be on? but not sure which ribbon (iphone) supplies power to the board a little help, please?