I8200n dead boot

[rohit.sharma73]

Originally Posted by Advance-Box

@anwar.welltech

Hi,

It is the same.

Tested Pinouts:
Take note of SMALL TP Pads which I show that needs to be connected to Ground.


Now Connect with ATF RJ-45



For Boot Files, I still need to make it for you.

Just Try to connect eMMC first and dump BOOT1 + BOOT2 (32MB each)
and USER Partition 512 MB for backup purposes.


Only use correct 1.80V and 3.30V external power supply. Using other voltages will not work properly.

If eMMC is hard to be detected by ATF Software, just disconnect RJ-45 Cable and try again. Once connection is established, you will be able to dump properly.

B.R.

hy use this test point proper attach but my phone this error show i use SMARTGSM ADPOTAR ORIGNAL PLZZZ SOL HERE

1. DO NOT USE THE PHONE"S BATTERY
2. Connect the Soldered TP Connections to ATF Box
3. Disconnect the USB Cable and Wait until the
the ATF Software will tell you to Connect the USB.

ERROR: EMMC WAS NOT Detected! (CMD1)
Check your Test Point Soldering!
CMD1 Reply: 0x00000000

[yivbu]

emmc pinout ? where picture ?