Killed home button replacing screen
 

Hi folks, newbie here...

I replaced the screen on my iPhone 6 because of a crack. Everything went swimmingly, except the part where you pull the screen assembly off. The homebutton ribbon was stuck, and even though I thought I was careful--I took my time and used a ****dryer on low to loosen the adhesive--I pulled the homebutton ribbon in two.

What do I need to do now? Buy a new homebutton and ribbon? Is there such a thing as a new screen assembly that contains an attached homebutton ribbon?

The screen works fine, and I have enabled assistive touch for now so my phone is working fine. But I'd like to have a working home button again.

Thanks in advance for any help. I feel like I was really close to getting this right the first time! :)

Thanks,

pktivey

You can get a replacement home button but you will lose touch id forever.

AP_BI_I2C1_SDA_MESA_CONN
BUTTON_TO_AP_MENU_KEY_L_CONN
MESA_TO_AP_INT_CONN
MESA_TO_AP_SPI_MISO_CONN
PP3V0_MESA
AP_BI_I2C1_SDA
MESA_TO_AP_SPI_MISO
MESA_TO_BOOST_EN_CONN
AP_TO_MESA_SPI_MOSI_CONN
PP16V5_MESA_CONN
PP3V0_MESA_CONN
AP_TO_I2C1_SCL_MESA_CONN
AP_TO_I2C1_SCL AP_TO_I2C1_SCL_MESA_CONN
PP16V5_MESA_CONN
BUTTON_TO_AP_MENU_KEY_L_CONN
AP_BI_I2C1_SDA_MESA_CONN
AP_TO_MESA_SPI_MOSI AP_TO_MESA_SPI_MOSI_CONN
AP_TO_MESA_SPI_CLK
PP3V0_MESA PP1V8_MESA PP1V8_MESA_CONN
AP_TO_MESA_SPI_CLK_CONN
PP1V8_MESA_CONN
051-9903
chek to j2118