can't repair deadboot SHV-E160K need help - GSM-Forum

ajmal786 · 10-14-2014, 08:59

Code:

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [Samsung E160K V1.0.4535.7001]

Connecting to the dead body...OK
Detected dead body ID: 0x106A10E1 - CORRECT!
Set I/O Voltage reads as 1.80V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 100 kHz]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0000 (000000, 0x000747C00000 Bytes = 29.12 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0000 (000000, 0x000000200000 Bytes = 2.00 MB)

Flashing the dead body...
ERROR: DCC Loader has reported Error Code = 0x35 (0x000000). Trying to recover...OK
ERROR: DCC Loader has reported Error Code = 0x35 (0x000000). Trying to recover...OK
ERROR: DCC Loader has reported Error Code = 0x35 (0x000000). Trying to recover...OK
ERROR: Stopped due to multiple communication errors. Terminating at 0x000000000000

need help.

i try change tck low to high but same.

maanarman · 10-14-2014, 10:55

try with charge battery and usb cable

i already face same problem with same model

10-14-2014, 10:55	#2 (permalink)
maanarman No Life Poster Join Date: Jan 2008 Location: PAKISTAN KARACHI Age: 44 Posts: 12,919 Member: 686395 Status: Offline Sonork: 100.1608345 Thanks Meter: 3,822	try with charge battery and usb cable i already face same problem with same model