Eror resurect sam B5330
 

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.49 (RIFFBOX1), JTAG Manager Version: 1.78
Selected Resurrector: [Samsung B5330 V1.0.4856.64036]

Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - IGNORED!
Set I/O Voltage reads as 1.81V, TCK Frequency is 8 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0100 (N5U00M, 0x0000E9000000 Bytes = 3.64 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0100 (N5U00M, 0x000000200000 Bytes = 2.00 MB)

Selected Resurrection Data for the eMMC Chip with Capacity = 3.64GB

Flashing the dead body...
WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
ERROR: DCC Loader has reported Error Code = 0x3E (0x007FFF <> 0x008000)

how fix this ...sir???

Try by emmc method.

Best regard.

done with easy jtag write dump 256bin ,used product B5330L..but still bootloop..flash with ufst still bloetooth ist emmc?

done ...with another flash file..tanks

The eMMC chip is bad and it will be dead in no time again.

CPU is cortex A9 and riff hav not yet ..for dcc loader..

to repair this we use easy jtag still metode jtag not isp i have pin out,and file dump from easy jtag server ,use product b5330l.

So Your phone was not B5330 but "L" version for Latin America market ?

stil b5330 sir..just borrow tab b5330L to write dump...in easy jtag..