G800 support wanted + pinout found

[Sethxp]

Hi, found pinout for Samsung G800


Pinout is :

Keypad -- TDO TRST RTCK NRST TCK TDI TMS GND (same as u700)

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.16, JTAG Manager Version: 1.21
Selected Resurrector: [Samsung U700]

Connecting to the target...OK
Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK

Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x200C00E1, IR Length = 0x04 bits
Total IR length: 0x0004 bits
____________________________________
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.16, JTAG Manager Version: 1.21
Selected Resurrector: [Samsung U700]

Getting EmbeddedICE-RT registers...OK
00 = 0x00000010 08 = 0x00000000 10 = 0x00000000
01 = 0x00000010 09 = 0x00000000 11 = 0x00000000
02 = 0x00000000 0A = 0x00000000 12 = 0x00000000
03 = 0x00000010 0B = 0x00000000 13 = 0x00000000
04 = 0x60000000 0C = 0x00000000 14 = 0x00000000
05 = 0x00000000 0D = 0x000000F7 15 = 0x000000F7
06 = 0x60000000 0E = 0x00000000 16 = 0x00000000
07 = 0x00000000 0F = 0x00000000 17 = 0x00000000

____________________________________
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.16, JTAG Manager Version: 1.21
Selected Resurrector: [Samsung U700]

Connecting to the dead body...OK
Detected dead body ID: 0x200C00E1 - IGNORED!
Set I/O Voltage reads as 2.59V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip ID: 0x00EC/0x0071 (256MB)

Reading FLASH1 address space from 0x00000000 to 0x0FFFFFFF
Failed to receive answer to READ command.