Galaxy TAB P1000N error

[Linkz]

Can someone tell me whether these errors can be corrected?

Also when i connect the galaxy tab i see this device SEC S5PC110 Test B/D, could the errors be the cause of that?

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.30, JTAG Manager Version: 1.38
Selected Resurrector: [Samsung Galaxy Tab]

Connecting to the dead body...OK
Detected dead body ID: 0x1BA00477 - CORRECT!
Set I/O Voltage reads as 2.81V, TCK Frequency is 8 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x0050 (512MB)
Flashing the dead body...OK
WARNING: Programming Error (0x24) at 0x0000000000 is handled as Cut Excess.
WARNING: Programming Error (0x24) at 0x0000A80000 is handled as Cut Excess.
WARNING: Programming Error (0x24) at 0x0000AC0000 is handled as Cut Excess.
WARNING: Programming Error (0x24) at 0x0000B40000 is handled as Cut Excess.
WARNING: Programming Error (0x24) at 0x0000BC0000 is handled as Cut Excess.
WARNING: Programming Error (0x24) at 0x0000C00000 is handled as Cut Excess.
Resurrection complete!