HTC Desire recover problem

[servis.kompa]

I have a HTC Desire, entry into the bootloader impossible.
Always see HTC logo and four triangles in corners

I did the next instruction

If phone wont enter bootloader after resurrection, do this :
1. Erase full flash
2. Do resurrection with IMEI , SuperCID and HTC Partition options
3. Upgrade ROM
This procedure is tested by many users already.


1. Erase flash, 4 errors

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.27, JTAG Manager Version: 1.36
Selected Resurrector: [HTC Desire]

Connecting to the dead body...OK
Detected dead body ID: 0x202400E1 - CORRECT!
Set I/O Voltage reads as 2.99V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Settings Code: 0x0000010000000000000000000004

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x55BC (512MB)

Erasing FLASH1 memory from 0x0000000000 to 0x001FFFFFFF...OK
WARNING: Erasing Error (0x24) at 0x0001D40000. Attempt to Repeat again.
WARNING: Erasing Error (0x24) at 0x0001D40000 is Ignored. Erase continues.
WARNING: Erasing Error (0x24) at 0x0012F20000 is Ignored. Erase continues.
WARNING: Erasing Error (0x24) at 0x0019100000 is Ignored. Erase continues.
Completed in 00:00:39.875 (Average Transfer Rate: 13148.29 kB/s)

2. Resurection, 1 errors

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.27, JTAG Manager Version: 1.36
Selected Resurrector: [HTC Desire]

Connecting to the dead body...OK
Detected dead body ID: 0x202400E1 - CORRECT!
Set I/O Voltage reads as 2.99V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x55BC (512MB)
Selected Resurrection Data for the NAND Chip with Page size = 2KB

Flashing the dead body...OK
WARNING: Programming Error (0x24) at 0x0001D40000 is handled as Cut Excess.
Resurrection complete!

If untick HTC Partition options no errors

3. Flash phone but stuck Recovery: updating .... wait.....

Hardware or software, solution?