htc raphael resurection problem

[sidramobilecare]

Dear riff team

i unlocked htc rph110 p4600 sucessfully with riff but it was still asking for code

[12/24/2011 11:22:58 PM] [START OPERATION_ID = RESURRECT]
[12/24/2011 11:24:14 PM] Open serial port...OK
[12/24/2011 11:24:14 PM] Connecting to the RIFF Box...OK
[12/24/2011 11:24:14 PM] Firmware Version: 1.28, JTAG Manager Version:

1.37
[12/24/2011 11:24:14 PM] Selected Resurrector: [HTC Raphael]
[12/24/2011 11:24:14 PM]
[12/24/2011 11:24:14 PM] Connecting to the dead body...OK
[12/24/2011 11:24:14 PM] Detected dead body ID: 0xA01700E1 -

CORRECT!
[12/24/2011 11:24:14 PM] Set I/O Voltage reads as 2.59V, TCK Frequency

is RTCK
[12/24/2011 11:24:14 PM] Adaptive Clocking RTCK Sampling is: [Sample at

MAX]
[12/24/2011 11:24:14 PM]
[12/24/2011 11:24:14 PM] Resurrection sequence started.
[12/24/2011 11:24:14 PM] Establish communication with the phone...OK
[12/24/2011 11:24:14 PM] Initializing internal hardware configuration...OK
[12/24/2011 11:24:14 PM] Uploading resurrector data into memory...OK
[12/24/2011 11:24:14 PM] Starting communication with resurrector...OK
[12/24/2011 11:24:14 PM]
[12/24/2011 11:24:14 PM] Detected an Initialized FLASH1 Chip, ID:

0x00AD/0x55BC (512MB)
[12/24/2011 11:24:14 PM] Unlocking the Phone...OK
[12/24/2011 11:24:14 PM] Unlock complete!
[12/24/2011 11:24:14 PM] [FINISH OPERATION_ID = RESURRECT]


so i resurected it



[12/25/2011 2:08:56 AM] [START OPERATION_ID = RESURRECT]
[12/25/2011 2:10:36 AM] Open serial port...OK
[12/25/2011 2:10:36 AM] Connecting to the RIFF Box...OK
[12/25/2011 2:10:36 AM] Firmware Version: 1.28, JTAG Manager Version:

1.37
[12/25/2011 2:10:36 AM] Selected Resurrector: [HTC Raphael]
[12/25/2011 2:10:36 AM]
[12/25/2011 2:10:36 AM] Connecting to the dead body...OK
[12/25/2011 2:10:36 AM] Detected dead body ID: 0xA01700E1 -

CORRECT!
[12/25/2011 2:10:36 AM] Set I/O Voltage reads as 2.59V, TCK Frequency is

RTCK
[12/25/2011 2:10:36 AM] Adaptive Clocking RTCK Sampling is: [Sample at

MAX]
[12/25/2011 2:10:36 AM]
[12/25/2011 2:10:36 AM] Resurrection sequence started.
[12/25/2011 2:10:36 AM] Establish communication with the phone...OK
[12/25/2011 2:10:36 AM] Initializing internal hardware configuration...OK
[12/25/2011 2:10:36 AM] Uploading resurrector data into memory...OK
[12/25/2011 2:10:36 AM] Starting communication with resurrector...OK
[12/25/2011 2:10:36 AM]
[12/25/2011 2:10:36 AM] Detected an Initialized FLASH1 Chip, ID:

0x00AD/0x55BC (512MB)
[12/25/2011 2:10:36 AM] Flashing the dead body...OK
[12/25/2011 2:10:36 AM] Resurrection complete!
[12/25/2011 2:10:36 AM] [FINISH OPERATION_ID = RESURRECT]

but after resurrection it is restarting on logo
it is also not detected with usb cable so i am unable to update rom
What should i do please?
can you please upload unlocked dump
thanks

[legija]

If You bothered to go trough stickies here on RIFF section, You could find how to read code from any HTC.
However, now You need to enter bootloader mode and update ROM.

Also, look at this part from "Resurrection Help":

Resurrector will reflash radio’s boot zone and will re-write PDA’s SPL to 1.90.0000 SPL version. Additionally, the zone which contains Model ID is re-flashed too. Thus after resurrection phone will have Model ID = ‘RAPH10000’.
As well, you can change CID - for this make sure ‘Repair Custom ID’ field is checked in the Resurrection Guide dialog.

[sidramobilecare]

Originally Posted by legija

If You bothered to go trough stickies here on RIFF section, You could find how to read code from any HTC.
However, now You need to enter bootloader mode and update ROM.

Also, look at this part from "Resurrection Help":

thanks sir,
i had read unlock codes with other tool but it was not accepting code
error was something like :
tried 7 times wait for timeout

it is also not detected with usb cable so i am unable to update rom
any other method i could revive it
thanks