huwei G510-0200 boot repair error

[shahidshan40]

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [Huawei G510 V1.0.5179.43973]

Connecting to the dead body...OK
Detected dead body ID: 0x107730E1 - IGNORED!
Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000048

any one genius plz guid me

[.::TEJARAM::.]

Originally Posted by shahidshan40

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [Huawei G510 V1.0.5179.43973]

Connecting to the dead body...OK
Detected dead body ID: 0x107730E1 - IGNORED!
Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000048

any one genius plz guid me

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000000



This error is returned by DCC loader in case that memory chip is not detected. Usually it hapens when chip it self is dead, or it's not powered.



User should replace memory chip, or in rare cases check power supply circuitry.

[topline]

g510-0100
hi, my problem is:
Connecting to the dead body...OK
Detected dead body ID: 0x107730E1 - WRONG!!!
ERROR: Current ID does not belong to the Huawei G510 family.

I await instructions for a quick solution ...
thank you