i9000 error pls hlp

[alimuamin]

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.28, JTAG Manager Version: 1.37
Selected Resurrector: [Samsung I9000]

Connecting to the dead body...OK
Detected dead body ID: 0x1BA00477 - CORRECT!
Set I/O Voltage reads as 2.80V, TCK Frequency is 8 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x0050 (512MB)
Flashing the dead body...
WARNING: Programming Error (0x25) at 0x0000000000. Attempting to Repeat.
WARNING: Programming Error (0x25) at 0x0000000000. Attempting to Repeat.
WARNING: Programming Error (0x25) at 0x0000000000. Attempting to Repeat.
WARNING: Programming Error (0x25) at 0x0000000000. Attempting to Repeat.
WARNING: Programming Error (0x25) at 0x0000000000. Attempting to Repeat.
WARNING: Programming Error (0x25) at 0x0000000000. Attempting to Repeat.
WARNING: Programming Error (0x25) at 0x0000000000. Attempting to Repeat.
WARNING: Programming Error (0x25) at 0x0000000000 is Ignored.
WARNING: Programming Error (0x25) at 0x0000A80000 is Ignored.
WARNING: Programming Error (0x25) at 0x0000AC0000 is Ignored.
WARNING: Programming Error (0x25) at 0x0000B00000 is Ignored.
WARNING: Programming Error (0x25) at 0x0000B80000 is Ignored.OK
Resurrection complete!

[BABAK NURI]

Hi

This error means,eMMC Have a Bad Block.....For repair,you need replace new one

But....What is Phone History? Also,Please tell me about Phone after resurrect...what happen?

[alimuamin]

thanks for replay and history is -first hang with start-up logo, so i try to re-flash but reach 60% flashing is shutdown . now no response, pls *******r is shouting

[BABAK NURI]

Hi

I think eMMC need to replace....but try this:

1-Full Flash Erase...
2-Resurrect with Repair "Clone Gremlin zone"

Of course you need check with both primary boot loaders (PBL)


Resurrection Help:

Current resurrector has two different versions of primary boot loaders (PBL) embedded. This depends on hardware version of your phone which boot to use, thus in case of failure (cannot enter download mode after resurrection) of first loader try selecting another.

In case after resurrection (after you have tried with both boot versions) the download mode is not initiated (LCD remains blank) do repeat resurrection with ‘Clone Gremlin zone’ option checked.