I9100 After Repair seen As (sec soc smdk board)

[a_1st]

What's The Wrong

I9100 After Repair seen in device manger As (sec soc smdk board)

Here The Log :

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [Samsung I9100 V1.0.4850.415]

Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 2.81V, TCK Frequency is 8 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0100 (000000, 0x000200000000 Bytes = 8.00 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0100 (000000, 0x000000100000 Bytes = 1.00 MB)

No Resurrection Data is available for the eMMC Chip with Capacity = 8.00GB
WARNING!!! Using Resurrection Data for the eMMC Chip with Capacity = 14.68GB

Flashing the dead body...OK
Resurrection complete!


and not power on or enter download mode

[jupizet]

have same prob>>
but my phone is m250s..korea i9100>>>

[BABAK NURI]

Hi

This is exactly Your Problem,,,,

Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0100 (000000, 0x000200000000 Bytes = 8.00 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0100 (000000, 0x000000100000 Bytes = 1.00 MB)

Your eMMC not have ID ,,,So,It's Happen with 2 Reason:
1-Fault eMMC
2-Refribush Chinese Phone

But Possible Your pcb have a new (8GB) chip with unknown identity

Please Connect Phone To RIFFBox and Contact Me Via Sonork...I Want Check Your Phone Via Remote for Problem