lg Lu 6200 boot repiar Done but not power On

[MALIKTARIQ]

lg Lu 6200 boot repiar Done but not power On
how to cleare this problem

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.55
Selected Resurrector: [LG LU6200 V1.0.5025.52349]

Connecting to the dead body...OK
Detected dead body ID: 0x105310E1 - IGNORED!
Set I/O Voltage reads as 1.80V, TCK Frequency is 6 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0090/0x014A (HYNIX, 0x0000D7800000 Bytes = 3.37 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0090/0x014A (HYNIX, 0x000000200000 Bytes = 2.00 MB)

Flashing the dead body...OK
Resurrection complete!

[Akhtar Ali Jatt]

Write Dump File .

[Akhtar Ali Jatt]

HERE iS 512MB DUMP FILE READ WITH RIFF BOX


LG LU6200 DUMP FILE 512MB BY AKHTAR ALI JATT