N7000 trying resurrection

[MUTUAL]

hi guys i m trying resurrection but always give me this error

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.32, JTAG Manager Version: 1.43
Selected Resurrector: [Samsung N7000 AP V1.0.4458.16492]

Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 2.79V, TCK Frequency is 8 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0001 (VYL00M, 0x0003AB400000 Bytes = 14.68 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0001 (VYL00M, 0x000000080000 Bytes = 0.50 MB)

Flashing the dead body...
WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
ERROR: DCC Loader has reported Error Code = 0x3E (0x007FFF <> 0x010000)

what to do?

[MUTUAL]

sorry for new post guy i already got my answer ignore this post

[ABOUSHADY]

try 1 MHz
or 2 MHz
or 4 MHz

only with usb no need battery

[BABAK NURI]

Originally Posted by MUTUAL

hi guys i m trying resurrection but always give me this error


WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
ERROR: DCC Loader has reported Error Code = 0x3E (0x007FFF <> 0x010000
what to do?

Hi
It's means eMMC is damage...You Need Change it By New One

Look Here:
RIFF JTAG Box FAQ - ERROR: DCC Loader has reported Error Code = 0x3E (0x007FFF 0x010000)