p705 dead boot help team - GSM-Forum

ganjbek · 11-15-2014, 07:03

phone is no downoad mode see zeus device help team

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [LG P715 V1.0.0.0]

Connecting to the dead body...OK
Detected dead body ID: 0x1077C0E1 - IGNORED!
Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at 1 MHz]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0045/0x0100 (SEM04G, 0x0000EC000000 Bytes = 3.69 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0045/0x0100 (SEM04G, 0x000000100000 Bytes = 1.00 MB)

Flashing the dead body...OK
Resurrection complete!

Rezzkull · 02-18-2015, 05:50

If pin jtag has damage....what can I do next??? please advice??? Is there any cap or resistor from cpu between pinout. Or there is direct to cpu?
Thank you.

11-15-2014, 07:03	#1 (permalink)
ganjbek No Life Poster Join Date: Feb 2010 Location: 90-region Age: 39 Posts: 938 Member: 1246378 Status: Offline Thanks Meter: 123	p705 dead boot help team phone is no downoad mode see zeus device help team Open serial port...OK Connecting to the RIFF Box...OK Firmware Version: 1.37, JTAG Manager Version: 1.56 Selected Resurrector: [LG P715 V1.0.0.0] Connecting to the dead body...OK Detected dead body ID: 0x1077C0E1 - IGNORED! Set I/O Voltage reads as 2.61V, TCK Frequency is RTCK Adaptive Clocking RTCK Sampling is: [Sample at 1 MHz] Resurrection sequence started. Establish communication with the phone...OK Initializing internal hardware configuration...OK Uploading resurrector data into memory...OK Starting communication with resurrector...OK Detected an Initialized FLASH1 Chip, ID: 0x0045/0x0100 (SEM04G, 0x0000EC000000 Bytes = 3.69 GB) Detected an Initialized FLASH2 Chip, ID: 0x0045/0x0100 (SEM04G, 0x000000100000 Bytes = 1.00 MB) Flashing the dead body...OK Resurrection complete!

02-18-2015, 05:50	#2 (permalink)
Rezzkull Junior Member Join Date: Jun 2007 Posts: 24 Member: 523637 Status: Offline Thanks Meter: 4	If pin jtag has damage....what can I do next??? please advice??? Is there any cap or resistor from cpu between pinout. Or there is direct to cpu? Thank you.