S5360 Resurrect Problem

[shahzaadbutt]

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.34, JTAG Manager Version: 1.47
Selected Resurrector: [Samsung S5360 V1.0.4443.1900]

Connecting to the dead body...OK
Detected dead body ID: 0x07B3617F - CORRECT!
Set I/O Voltage reads as 2.99V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x0050 (512MB)
Selected Resurrection Data for the NAND Chip with Page size = 4KB

Flashing the dead body...OK
WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000080000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000100000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000280000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000000300000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000001280000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x000001300000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x00001FF00000 is handled as Cut Excess.
WARNING: Programming Error (0x25) at 0x00001FF80000 is handled as Cut Excess.
Resurrection complete!