samsung i9001 dead boot repair error

[anw]

pls help me riff box team


Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.35, JTAG Manager Version: 1.49
Selected Resurrector: [Samsung I9001 V1.00]

Connecting to the dead body...OK
Detected dead body ID: 0x27B360E1 - CORRECT!
Set I/O Voltage reads as 2.60V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000035

ERROR: Selected FLASH Chip was not initialized by the DCC Loader.


THIS ERROR

BR
ANW

[BABAK NURI]

Hi

Your eMMC Chip is Not Detected By DCC Loader,,,, So You Have :

1- Damaged eMMC
2- Bad Soldering Or Short Some Pin To Other Place

[ramoon20]

Originally Posted by BABAK NURI

Hi

Your eMMC Chip is Not Detected By DCC Loader,,,, So You Have :

1- Damaged eMMC
2- Bad Soldering Or Short Some Pin To Other Place

************************************************** **********

Hi ser nuri.

I need your help pls I have samsung I9001 dead boot during installing unthrusted aplication and

phone went dead


phone resurrect ok but no download mode phone

totaly dead I put jig with 300K resistor worck fin

with others phone tested many time sure

Here is log