Samsung I9100 Error

[maplegsm]

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.51
Selected Resurrector: [Samsung I9100 V1.0.4850.415]

Connecting to the target...OK
Set I/O Voltage reads as 2.80V, TCK Frequency is 8 MHz

Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x4BA00477, IR Length = 0x04 bits
Total IR length: 0x0004 bits

Analizing IDCODE(s) of the JTAG scan chain:
1. 0x4BA00477: Generic CORTEX-A9/A15 Core Based Target




Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.51
Selected Resurrector: [Samsung I9100 V1.0.4850.415]

Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 2.80V, TCK Frequency is 8 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000048

No Resurrection Data is available for the eMMC Chip with Capacity = 0B
WARNING!!! Using Resurrection Data for the eMMC Chip with Capacity = 14.68GB

ERROR: Selected FLASH Chip was not initialized by the DCC Loader.

[BABAK NURI]

Hi
This error come from damaged eMMC Chip,Need Replace By New One

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000048